How To Fix MD495 - You can display a maximum of &1 curves at the same time

SAP Error Message - Details

• Message type: E = Error

• Message class: MD - Material Requirements Planning (MRP)

• Message number: 495

• Message text: You can display a maximum of &1 curves at the same time

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message MD495 - You can display a maximum of &1 curves at the same time ?

  The SAP error message MD495, which states "You can display a maximum of &1 curves at the same time," typically occurs in the context of the SAP system when you are trying to display more data than the system allows in a graphical representation, such as in a planning or forecasting scenario.
  Cause:
  The error is caused by exceeding the system's limit for the number of curves (or data series) that can be displayed simultaneously in a graphical output. This limit is set to ensure system performance and usability, as displaying too many curves can lead to performance degradation and make the output difficult to interpret.
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Reduce the Number of Curves: Try to limit the number of curves you are attempting to display. You can do this by:
  
  Filtering the data to show only the most relevant curves.
  Selecting a smaller subset of data for analysis.
  
  
  
  Change Display Settings: If applicable, check if there are settings in the display options that allow you to adjust the maximum number of curves shown.
  
  
  Use Different Views: If the data can be segmented, consider using different views or reports to analyze the data in smaller groups.
  
  
  Consult Documentation: Check the SAP documentation or help files for any specific guidelines on the maximum number of curves allowed for the particular transaction or report you are using.
  
  
  System Configuration: If you frequently need to display more curves than the limit allows, you may want to consult with your SAP Basis or system administrator to see if the limit can be adjusted in the system configuration. However, this should be done with caution, as it may impact system performance.
  
  
  Related Information:
  
  Transaction Codes: The error may occur in various transaction codes related to planning and forecasting, such as MD04 (Stock/Requirements List) or MD61 (Create Planning Scenario).
  SAP Notes: Check for any relevant SAP Notes that may address this issue or provide additional guidance.
  Performance Considerations: Always consider the performance implications of displaying large amounts of data in SAP, as it can affect not only your session but also the overall system performance.
  
  If the problem persists after trying these solutions, it may be beneficial to reach out to your SAP support team for further assistance.