How To Fix MD325 - Storage loc. &3 does not belong to the same MRP area as storage loc. &3

SAP Error Message - Details

• Message type: E = Error

• Message class: MD - Material Requirements Planning (MRP)

• Message number: 325

• Message text: Storage loc. &3 does not belong to the same MRP area as storage loc. &3

What causes this issue?

The storage location &V1& belongs to MRP area &V2&.
If you change the storage location, the assignment to the MRP area also
changes. The storage location &V3& belongs to the MRP area &V4&.

System Response

You are not allowed to change the MRP area here.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message MD325 - Storage loc. &3 does not belong to the same MRP area as storage loc. &3 ?

  The SAP error message MD325 indicates that there is a mismatch between the storage locations in the context of Material Requirements Planning (MRP). Specifically, it means that the storage location specified in the error does not belong to the same MRP area as another storage location being referenced in the transaction.
  Cause:
  
  MRP Area Configuration: The storage location in question is not assigned to the same MRP area as the other storage location involved in the transaction. MRP areas are used to manage planning at a more granular level than just plant-wide planning.
  Data Entry Error: There may be a mistake in the data entry where the wrong storage location is being referenced.
  Master Data Issues: The material master data may not be correctly configured, leading to inconsistencies in MRP area assignments.
  
  Solution:
  
  
  Check MRP Area Assignment:
  
  Go to the material master record (transaction code MM03) and check the MRP area assignments for the material in question.
  Ensure that both storage locations are assigned to the same MRP area.
  
  
  
  Adjust Storage Location:
  
  If the storage location is incorrectly assigned, you may need to change the storage location or reassign it to the correct MRP area.
  
  
  
  Review MRP Area Configuration:
  
  If necessary, review the configuration of MRP areas in your system (transaction code OMD0) to ensure that they are set up correctly and that the storage locations are included in the appropriate MRP areas.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for more detailed guidance on MRP area configuration and management.
  
  
  
  Contact Support:
  
  If the issue persists after checking the above points, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  
  
  Related Information:
  
  MRP Areas: MRP areas allow for more detailed planning and can be defined at various levels, such as plant, storage location, or even at a specific production line.
  Material Master Data: The material master contains all the information related to a material, including its MRP settings, which can affect how materials are planned and managed in the system.
  Transaction Codes:
  
  MM03: Display Material Master
  OMD0: MRP Area Configuration
  
  
  
  By following these steps, you should be able to resolve the MD325 error and ensure that your MRP areas and storage locations are correctly configured.