How To Fix MCW_AA_AT012 - More than one time parameter set in customizing for query &1

SAP Error Message - Details

• Message type: E = Error

• Message class: MCW_AA_AT - Messages for Allocation Rule Generation Based on BW

• Message number: 012

• Message text: More than one time parameter set in customizing for query &1

What causes this issue?

In the customizing for calling query &V1& in SAP BW more than one
variable is maintained for the analysis period of the data selection.
Exactly one time variable is needed to determine the data format for
the selection of the allocation table generation.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

If you have the necessary authorization, adjust the data in customizing
to 'Data retraction for Retail/CP' (transaction MCW_AA), otherwise
notify your system administrator.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message MCW_AA_AT012 - More than one time parameter set in customizing for query &1 ?

  The SAP error message MCW_AA_AT012 indicates that there is an issue with the configuration of a query in the SAP system, specifically related to the time parameters. The message states that more than one time parameter set has been defined in the customizing for the query identified by &1.
  Cause:
  This error typically occurs when:
  
  Multiple Time Parameters: The query has been configured with more than one set of time parameters, which is not allowed. SAP queries can only have a single time parameter set to ensure clarity and avoid ambiguity in data retrieval.
  Customizing Errors: There may be an error in the customizing settings where multiple time parameters have been inadvertently defined for the same query.
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Query Customizing:
  
  Go to the transaction code SQ01 (SAP Query) or SQ02 (InfoSet).
  Locate the query that is causing the error.
  Review the time parameter settings in the query definition.
  
  
  
  Remove Duplicate Time Parameters:
  
  If you find that there are multiple time parameter sets defined, you will need to remove the duplicates.
  Ensure that only one time parameter set is active for the query.
  
  
  
  Adjust Query Settings:
  
  If necessary, adjust the query settings to ensure that they align with the intended data retrieval requirements.
  Save the changes and test the query again to see if the error persists.
  
  
  
  Transport Changes:
  
  If you are working in a development environment and the query is to be transported to production, ensure that the changes are properly transported.
  
  
  
  Consult Documentation:
  
  If you are unsure about the correct configuration, refer to SAP documentation or consult with a colleague who has experience with SAP queries.
  
  
  
  Related Information:
  
  Transaction Codes: SQ01 (SAP Query), SQ02 (InfoSet), SQ03 (User Groups).
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional guidance.
  SAP Community: Consider searching or posting in the SAP Community forums for insights from other users who may have encountered similar issues.
  
  By following these steps, you should be able to resolve the error message MCW_AA_AT012 and successfully configure your query.