How To Fix MCEX008 - Extractor only defined for the "Full" and "Init" modes

MCEX008 - Overview

• Message type: E = Error

• Message class: MCEX - Extraction Interface LIS/BW

• Message number: 008

• Message text: Extractor only defined for the "Full" and "Init" modes

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

MCEX008 - Details

• The SAP error message MCEX008 indicates that a specific extractor is only defined for "Full" and "Init" modes, which means that it cannot be used in "Delta" mode. This error typically occurs when you attempt to run a data extraction process in a mode that is not supported by the extractor.
  
  Cause:
  
  Extractor Configuration: The extractor you are trying to use is configured to only support full data loads or initialization loads. This is common for certain types of data sources where delta extraction is not applicable.
  Data Source Type: Some data sources, especially those that do not have a change log or do not support change pointers, are limited to full or initialization extraction.
  Incorrect Mode Selection: The error may also arise if the extraction mode is incorrectly set in the data extraction process.
  
  
  Solution:
  
  Change Extraction Mode: If you are trying to run the extractor in delta mode, switch to either "Full" or "Init"