How To Fix MAFWKF489 - Key figure &1: yield key figures &2 and &3 have different yield intervals

MAFWKF489 - Overview

• Message type: E = Error

• Message class: MAFWKF - Analyzer Framework: Messages for Key Figures

• Message number: 489

• Message text: Key figure &1: yield key figures &2 and &3 have different yield intervals

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

MAFWKF489 - Details

• The SAP error message MAFWKF489 indicates that there is a mismatch in the yield intervals of the key figures involved in a calculation or reporting process. This typically occurs in the context of SAP's Advanced Planning and Optimization (APO) or similar modules where yield calculations are performed.
  
  Cause:
  The error arises when two or more yield key figures (in this case, &2 and &3) are defined with different yield intervals. Yield intervals are the time periods over which yields are calculated, and if they do not match, SAP cannot perform the necessary calculations or aggregations.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Check Key Figure Definitions:
  
  Go to the key figure definitions in the relevant planning area or data model.
  Verify the yield intervals for the key figures involved (i.e., &2 and &3). Ensure that they are set to the same interval (e.g., daily, weekly, monthly).
  
  
  
  Adjust Key Figure Settings:
  
  If the intervals are different,