How To Fix LTSK003 - Task priority has not been calculated for resource &1 at task selection

SAP Error Message - Details

• Message type: E = Error

• Message class: LTSK - Messages from Task package

• Message number: 003

• Message text: Task priority has not been calculated for resource &1 at task selection

What causes this issue?

Priority calculation during selection has not been performed due to the
processing of one task only. This may be due to one of the following
reasons:
The resource has selected by handling unit and there is only one task
from the selected handling unit.
The resource has selected in system-guided mode and has a manually
assigned task.
The resource has selected in system-guided mode and only one task has
been retrieved from the task pool.

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message LTSK003 - Task priority has not been calculated for resource &1 at task selection ?

  The SAP error message LTSK003 indicates that the task priority has not been calculated for a specific resource during the task selection process in the Logistics Execution (LE) module, particularly in the context of transportation management or warehouse management.
  Cause:
  The error can occur due to several reasons, including:
  
  
  Missing Configuration: The system may not have the necessary configuration for calculating task priorities for the specified resource. This could be due to missing settings in the transportation management or warehouse management configuration.
  
  
  Resource Settings: The resource (e.g., a vehicle, warehouse worker, etc.) may not have been properly defined or may lack the necessary attributes that allow the system to calculate a priority.
  
  
  Task Definition: The task itself may not have the required parameters or attributes set up that are needed for priority calculation.
  
  
  Master Data Issues: There may be issues with the master data related to the resource or task, such as missing or incorrect entries.
  
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Configuration:
  
  Review the configuration settings for task priority calculation in the relevant SAP module (e.g., LE, TM).
  Ensure that all necessary parameters for task priority calculation are defined.
  
  
  
  Review Resource Settings:
  
  Verify that the resource (e.g., vehicle, employee) is correctly defined in the system.
  Check if the resource has the necessary attributes and settings that allow for priority calculation.
  
  
  
  Examine Task Definition:
  
  Look into the task definition to ensure that it has all required parameters set up correctly.
  Make sure that the task is linked to the correct resource and that all necessary data is available.
  
  
  
  Check Master Data:
  
  Ensure that all relevant master data (e.g., resource master, task master) is complete and accurate.
  Correct any inconsistencies or missing data.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific guidance on task priority calculation and related configuration.
  
  
  
  Testing:
  
  After making the necessary changes, test the task selection process again to see if the error persists.
  
  
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like SPRO for configuration, LT03 for creating transfer orders, or LT12 for confirming transfer orders.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Support: If the issue persists after following the above steps, consider reaching out to SAP support or your internal SAP support team for further assistance.
  
  By following these steps, you should be able to identify and resolve the cause of the LTSK003 error message in SAP.