How To Fix LTR2_UI_CM078 - Default mapping mode set to '&1'

SAP Error Message - Details

• Message type: E = Error

• Message class: LTR2_UI_CM - Message Class for Content Module Editor

• Message number: 078

• Message text: Default mapping mode set to '&1'

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message LTR2_UI_CM078 - Default mapping mode set to '&1' ?

  The SAP error message LTR2_UI_CM078, which states "Default mapping mode set to '&1'", typically occurs in the context of SAP Landscape Transformation (SLT) or SAP Data Services when there is an issue with the mapping configuration for data replication or transformation.
  Cause:
  
  Mapping Configuration Issue: The error usually indicates that the default mapping mode is not set correctly or is not recognized. This can happen if the mapping mode is not defined in the system or if there is a mismatch in the expected configuration.
  Missing or Incorrect Parameters: The parameter '&1' in the error message usually represents a specific mapping mode that is either not available or incorrectly configured in the system.
  System Configuration: There may be issues with the overall configuration of the SLT or Data Services environment, including missing components or incorrect settings.
  
  Solution:
  
  Check Mapping Configuration: Review the mapping configuration in the SLT or Data Services settings. Ensure that the mapping mode specified is valid and correctly set up.
  Update Default Mapping Mode: If the default mapping mode is not set correctly, you may need to update it to a valid mode. This can typically be done in the configuration settings of the SLT or Data Services.
  Consult Documentation: Refer to the official SAP documentation for SLT or Data Services to understand the valid mapping modes and how to configure them properly.
  System Logs: Check the system logs for any additional error messages or warnings that may provide more context about the issue.
  SAP Support: If the issue persists, consider reaching out to SAP Support for assistance. They can provide more detailed guidance based on your specific system configuration and version.
  
  Related Information:
  
  SAP Notes: Look for relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Community Forums: Check SAP Community forums or other user groups where similar issues may have been discussed.
  Version Compatibility: Ensure that your version of SLT or Data Services is compatible with the mapping modes you are trying to use.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.