How To Fix LTR2_CM_CHECK_NROBJ011 - Object &1 added with mapping mode &2

SAP Error Message - Details

• Message type: E = Error

• Message class: LTR2_CM_CHECK_NROBJ - LTR2 Checks on Number Range Objects of Content Module

• Message number: 011

• Message text: Object &1 added with mapping mode &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message LTR2_CM_CHECK_NROBJ011 - Object &1 added with mapping mode &2 ?

  The SAP error message LTR2_CM_CHECK_NROBJ011 typically occurs in the context of SAP Landscape Transformation (SLT) or Data Replication processes. This error indicates that an object (like a table or view) has been added with a specific mapping mode, which may not be compatible with the current configuration or settings.
  Cause:
  The error can arise due to several reasons:
  
  Incompatible Mapping Mode: The mapping mode specified for the object may not be supported or may conflict with existing configurations.
  Configuration Issues: There may be issues with the configuration of the SLT system or the source/target systems.
  Object Already Exists: The object might already exist in the target system with a different mapping mode or settings.
  Data Model Changes: Changes in the data model or structure of the source system that are not reflected in the SLT configuration.
  
  Solution:
  To resolve the error, you can take the following steps:
  
  
  Check Mapping Mode: Verify the mapping mode specified for the object. Ensure that it is compatible with the existing configurations and the data model.
  
  
  Review Configuration: Go through the SLT configuration settings to ensure that everything is set up correctly. This includes checking the source and target system configurations.
  
  
  Consistency Check: Perform a consistency check on the SLT configuration to identify any discrepancies or issues.
  
  
  Reconfigure Object: If the object is already present in the target system, consider reconfiguring it or removing it and then re-adding it with the correct mapping mode.
  
  
  Consult Documentation: Refer to the SAP documentation for SLT and the specific error message for additional context and troubleshooting steps.
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance.
  
  
  Support: If the issue persists, consider reaching out to SAP support for assistance, providing them with the error details and the steps you have already taken.
  
  
  Related Information:
  
  SAP SLT Documentation: Familiarize yourself with the SAP Landscape Transformation documentation for best practices and configuration guidelines.
  Error Logs: Check the SLT error logs for more detailed information about the error and any related issues.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed.
  
  By following these steps, you should be able to identify the root cause of the error and implement a suitable solution.