How To Fix LTR2_CM_CHECK_FLT2001 - No filters in the content module

SAP Error Message - Details

• Message type: E = Error

• Message class: LTR2_CM_CHECK_FLT2 - LTR2 Checks on Filter2of Content Module

• Message number: 001

• Message text: No filters in the content module

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message LTR2_CM_CHECK_FLT2001 - No filters in the content module ?

  The SAP error message LTR2_CM_CHECK_FLT2001: No filters in the content module typically occurs in the context of SAP Landscape Transformation (SLT) or SAP Data Services when there are no filters defined for a content module that is expected to have them. This can prevent data replication or transformation processes from executing correctly.
  Cause:
  
  Missing Filters: The content module is expected to have filters defined, but none are present. Filters are used to specify which data should be included or excluded during the data replication or transformation process.
  Configuration Issues: There may be a misconfiguration in the SLT or Data Services setup, leading to the absence of filters.
  Incorrect Module Selection: The wrong content module may have been selected, which does not have any filters defined.
  
  Solution:
  
  
  Define Filters: 
  
  Go to the relevant content module in the SLT or Data Services configuration.
  Define the necessary filters that specify the data to be processed. This can include conditions based on specific fields or values.
  
  
  
  Check Configuration:
  
  Review the configuration settings for the content module to ensure that it is set up correctly.
  Ensure that the content module is intended to have filters and that you are using the correct module.
  
  
  
  Consult Documentation:
  
  Refer to the SAP documentation for SLT or Data Services to understand the requirements for filters in content modules.
  Check for any specific notes or guidelines related to the version of SAP you are using.
  
  
  
  Testing:
  
  After defining the filters, test the configuration to ensure that the error is resolved and that data replication or transformation works as expected.
  
  
  
  Seek Support:
  
  If the issue persists after defining filters and checking configurations, consider reaching out to SAP support or consulting with an SAP expert for further assistance.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  SLT Documentation: Review the official SAP SLT documentation for best practices on setting up content modules and filters.
  Community Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to resolve the LTR2_CM_CHECK_FLT2001 error and ensure that your data replication or transformation processes function correctly.