How To Fix LTR2_BASIS_CHECK640 - Parameter &1 is specified as SND-client. The value &2 is not necessary.

SAP Error Message - Details

• Message type: E = Error

• Message class: LTR2_BASIS_CHECK - LTR2 Messages of Checks in Check Framework

• Message number: 640

• Message text: Parameter &1 is specified as SND-client. The value &2 is not necessary.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message LTR2_BASIS_CHECK640 - Parameter &1 is specified as SND-client. The value &2 is not necessary. ?

  The SAP error message LTR2_BASIS_CHECK640 indicates that there is an issue with the configuration of the SND-client parameter in the SAP Landscape Transformation (SLT) system. Specifically, the error message states that the parameter &1 (which represents the SND-client) is set to a value &2 that is not necessary or valid.
  Cause:
  
  Incorrect Configuration: The SND-client parameter may have been set incorrectly in the SLT configuration. This could happen if the client number specified is not required or is not valid for the current setup.
  Client-Specific Settings: The system may be expecting a specific client configuration that is not being met, leading to this error.
  Legacy or Obsolete Settings: If the system has been upgraded or changed, there may be legacy settings that are no longer applicable.
  
  Solution:
  
  Check Configuration: Review the SLT configuration settings in transaction LTRC or LTR2. Ensure that the SND-client parameter is set correctly according to the requirements of your landscape.
  Remove Unnecessary Values: If the SND-client parameter is not needed, consider removing it or setting it to a default value that is appropriate for your system.
  Consult Documentation: Refer to the SAP documentation for SLT to understand the correct settings for the SND-client parameter and any dependencies it may have.
  System Check: Ensure that the SLT system is properly connected to the source and target systems, and that all necessary configurations are in place.
  Contact SAP Support: If the issue persists after checking the configuration, consider reaching out to SAP support for further assistance.
  
  Related Information:
  
  Transaction Codes: 
  
  LTRC: SLT Configuration
  LTR2: SLT Monitoring
  
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on configuring the SLT system.
  Documentation: Review the SAP Help Portal for SLT to get detailed information on configuration parameters and best practices.
  
  By following these steps, you should be able to resolve the LTR2_BASIS_CHECK640 error and ensure that your SLT configuration is correct.