How To Fix LMON015 - Unit &1 does not belong to unit type &2

LMON015 - Overview

• Message type: E = Error

• Message class: LMON - Monitor messages

• Message number: 015

• Message text: Unit &1 does not belong to unit type &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message LMON015 - Unit &1 does not belong to unit type &2 ?

  The SAP error message LMON015 indicates that there is a mismatch between the unit of measure (UoM) being used and the expected unit type in the system. Specifically, the error message states that the unit &1 does not belong to the unit type &2. This typically occurs in scenarios involving inventory management, logistics, or any module where units of measure are critical.
  
  Cause:
  
  Incorrect Unit of Measure: The unit of measure being used in a transaction or configuration does not match the expected unit type defined in the system.
  
  Configuration Issues: The unit of measure may not be properly configured in the system, or it may not be assigned to the correct unit type.
  Data Entry Errors: Users may have entered an incorrect unit of measure during data entry, leading to this error.
  Master Data Issues: The material master or other relevant master data may not have the correct unit of measure assigned.
  
  
  Solution:
  
  
  Check Unit of