How To Fix LM186 - Interim limit not subject to release procedure

SAP Error Message - Details

• Message type: E = Error

• Message class: LM - Treasury: Limit Management

• Message number: 186

• Message text: Interim limit not subject to release procedure

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message LM186 - Interim limit not subject to release procedure ?

  The SAP error message LM186, which states "Interim limit not subject to release procedure," typically occurs in the context of the SAP Logistics module, particularly when dealing with inventory management and material movements. This error indicates that the system has encountered an interim limit that is not configured to go through the standard release procedure.
  Cause:
  
  Configuration Issue: The interim limit may not be set up correctly in the system. This can happen if the configuration for the release procedure is not properly defined for the specific material or movement type.
  Material Master Settings: The material master record may not have the necessary settings that allow it to be subject to the release procedure.
  Movement Type: The movement type being used may not be configured to allow for the release procedure, leading to this error when trying to process a transaction.
  
  Solution:
  
  
  Check Configuration:
  
  Go to the configuration settings in SAP (Transaction SPRO) and navigate to the relevant section for the release procedure.
  Ensure that the interim limit is correctly configured to be subject to the release procedure.
  
  
  
  Review Material Master:
  
  Check the material master record for the specific material that is causing the error. Ensure that the relevant fields are set correctly to allow for the release procedure.
  You can use transaction MM03 to view the material master data.
  
  
  
  Movement Type Settings:
  
  Verify the settings for the movement type being used. You can check this in the configuration settings under Inventory Management.
  Ensure that the movement type is set up to allow for the release procedure.
  
  
  
  Consult Documentation:
  
  Review SAP documentation or help files related to the release procedure and interim limits to ensure that all necessary steps have been followed.
  
  
  
  Testing:
  
  After making any changes, perform a test transaction to see if the error persists. If it does, further investigation may be needed.
  
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on configuration.
  User Forums: Consider visiting SAP community forums or user groups where similar issues may have been discussed.
  Support: If the issue persists after checking the configuration and settings, consider reaching out to your SAP support team for further assistance.
  
  By following these steps, you should be able to identify the cause of the LM186 error and implement a solution to resolve it.