How To Fix LESI052 - Angle has to be defined between 0 and 360 degrees

LESI052 - Overview

• Message type: E = Error

• Message class: LESI - Messages for LES-TRM Interface package

• Message number: 052

• Message text: Angle has to be defined between 0 and 360 degrees

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message LESI052 - Angle has to be defined between 0 and 360 degrees ?

  The SAP error message LESI052 indicates that an angle value entered in the system is outside the acceptable range of 0 to 360 degrees. This error typically occurs in scenarios involving logistics, such as when defining angles for certain operations in warehouse management or transportation management.
  
  Cause:
  The error is triggered when:
  
  An angle value is entered that is less than 0 degrees or greater than 360 degrees.
  The angle might be derived from calculations or user input that does not conform to the expected range.
  
  
  Solution:
  To resolve the error, you should:
  
  Check Input Values: Review the angle value you are trying to enter. Ensure that it is within the range of 0 to 360 degrees.
  Adjust Calculations: If the angle is calculated based on other parameters, verify the calculations to ensure they yield a valid angle.
  Correct Data Entry: If the angle was entered manually, correct it to fall within the specified range.
  Consult Documentation: If you are