How To Fix LAW2_MESSAGES518 - No measurement result exists for system &1

SAP Error Message - Details

• Message type: E = Error

• Message class: LAW2_MESSAGES - LAW 2.0 Message Class

• Message number: 518

• Message text: No measurement result exists for system &1

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message LAW2_MESSAGES518 - No measurement result exists for system &1 ?

  The SAP error message LAW2_MESSAGES518, which states "No measurement result exists for system &1," typically occurs in the context of SAP Landscape Management (LaMa) or when dealing with system measurements and performance metrics. This error indicates that the system you are querying does not have any recorded measurement results available.
  Cause:
  
  No Measurement Data Collected: The most common cause is that the system in question has not had any measurement data collected. This could be due to the measurement not being configured or scheduled properly.
  Measurement Configuration Issues: There may be issues with the configuration of the measurement settings, leading to no data being captured.
  Data Retention Policies: If the measurement data has been purged or is outside the retention period, it may not be available for retrieval.
  System Status: The system might be in a state where measurements cannot be taken (e.g., it is down or not properly connected).
  
  Solution:
  
  Check Measurement Configuration: Ensure that the measurement settings for the system are correctly configured. This includes verifying that the measurement types you want to collect are enabled.
  Schedule Measurements: If measurements are not scheduled, set up a measurement job to start collecting data. This can usually be done through the SAP LaMa interface.
  Review Data Retention Settings: Check the data retention settings to ensure that measurement data is not being deleted prematurely.
  System Status Check: Ensure that the system is up and running, and that it is properly connected to the monitoring tools.
  Manual Measurement: If necessary, you can try to manually trigger a measurement to see if data is collected.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Documentation: Refer to the SAP documentation for Landscape Management or the specific module you are working with for detailed instructions on configuring measurements.
  Support: If the issue persists after checking the above points, consider reaching out to SAP Support for further assistance.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.