How To Fix L6070 - Selected storage type & cannot be posted to R/2

SAP Error Message - Details

• Message type: E = Error

• Message class: L6 - LVS Link R/2 - ECC

• Message number: 070

• Message text: Selected storage type & cannot be posted to R/2

What causes this issue?

You attempted to clear inventory differences or accumulated stock data
that is to be transmitted from the ERP to the R/2 system. However, you
have selected a storage type that has not been defined as an
<GL:interim_storage_area>interim storage area</>. (The storage type you
selected has either a <GL:stock_placement_strategy>stock placement</> or
<GL:stock removal strategy>stock removal strategy</>.)

System Response

The transaction was interrupted.

How to fix this error?

Start the transaction again or select a valid storage type.
&FURTHER_HINTS&
For further information about clearing inventory differences or the
cumulative transmission of differences from R/3 to R/2, refer to the
<LS>MM Warehouse Management Guide.</>

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message L6070 - Selected storage type & cannot be posted to R/2 ?

  The SAP error message L6070, which states "Selected storage type & cannot be posted to R/2," typically occurs in the context of inventory management and logistics when there is an issue with the storage type configuration or the integration between SAP R/3 and R/2 systems.
  Cause:
  
  Storage Type Configuration: The storage type you are trying to use may not be configured correctly in the system. It might not be set up to allow postings to the R/2 system.
  Integration Issues: If you are using a legacy R/2 system alongside R/3, there may be issues with the integration settings or the communication between the two systems.
  Master Data Issues: The material master or storage location data may not be correctly set up for the storage type in question.
  Authorization Issues: The user may not have the necessary authorizations to post to the specified storage type.
  
  Solution:
  
  
  Check Storage Type Configuration:
  
  Go to the configuration settings for the storage type in the SAP system (Transaction code: SPRO).
  Ensure that the storage type is correctly defined and that it is allowed for postings to R/2.
  
  
  
  Review Integration Settings:
  
  Check the settings for the interface between R/3 and R/2. Ensure that the necessary configurations are in place for data transfer.
  Verify that the communication channels are functioning correctly.
  
  
  
  Verify Master Data:
  
  Check the material master data and ensure that the storage location and storage type are correctly assigned.
  Make sure that the material is allowed to be stored in the specified storage type.
  
  
  
  Check User Authorizations:
  
  Ensure that the user has the necessary authorizations to perform postings to the specified storage type.
  Review the user roles and profiles to confirm that they include the required permissions.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for specific details related to the error message and its resolution.
  
  
  
  Related Information:
  
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as:
  
  SPRO: Customizing settings.
  MM01/MM02: Material master creation and modification.
  LX01: Display stock overview.
  
  
  
  SAP Notes: Check for any SAP Notes related to this error message for additional insights or patches that may resolve the issue.
  
  
  Support: If the issue persists after checking the above points, consider reaching out to SAP support or your internal SAP team for further assistance.
  
  
  By following these steps, you should be able to identify and resolve the cause of the L6070 error message in your SAP system.