How To Fix JIT00080 - Control profile &1 (internal calls, buffer area) does not exist

JIT00080 - Overview

• Message type: E = Error

• Message class: JIT00 - JIT: Messages for JIT Process

• Message number: 080

• Message text: Control profile &1 (internal calls, buffer area) does not exist

What causes this issue?

Control profile &V1& should be used to control an internal JIT call/
buffer storage. However, this profile does not yet exist.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check the settings in Customizing (<DS:SIMG.SIMG_CFMENULEOJIT8>Define
control profile</>)and the entries of the control profiles in the
<DS:TRAN.JITV>JIT basic data</> in the components group type.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message JIT00080 - Control profile &1 (internal calls, buffer area) does not exist ?

  The SAP error message JIT00080 indicates that a control profile specified in the system does not exist. This error typically arises in the context of Just-In-Time (JIT) processing, where the system is trying to access a control profile that has not been defined or has been incorrectly configured.
  
  Cause:
  
  Missing Control Profile: The control profile specified in the configuration does not exist in the system.
  Incorrect Configuration: The control profile may have been deleted or not properly set up in the system.
  Typographical Error: There may be a typo in the control profile name when it was referenced in the configuration.
  Transport Issues: If the control profile was recently transported from another system, it may not have been included in the transport request.
  
  
  Solution:
  
  
  Check Control Profile Configuration:
  
  Go to the relevant transaction (e.g., JIT configuration) and verify if the control profile exists.
  If it does not exist, you may need to create a new control profile or restore