How To Fix JB010 - Error occurred when reading table &1. Processing was terminated

SAP Error Message - Details

• Message type: E = Error

• Message class: JB - General Message Class for IS-B (Development Class JBD)

• Message number: 010

• Message text: Error occurred when reading table &1. Processing was terminated

What causes this issue?

An error occurred when reading table &V1&. ,,,,

System Response

The program must show this termination message because the data that
should have been read is required for further processing.

How to fix this error?

First check (or ask your system administrator to check) whether the
table exists.
If the table does exist, and its status is active, check the selection
conditions and the table entry to be selected.
Check that you have the necessary authorization for read-only access or
whether the table is locked by another user.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message JB010 - Error occurred when reading table &1. Processing was terminated ?

  The SAP error message JB010, which states "Error occurred when reading table &1. Processing was terminated," typically indicates that there was an issue accessing a specific database table during processing. The &1 placeholder will be replaced with the name of the table that is causing the error.
  Possible Causes:
  
  Table Locking: The table may be locked by another process, preventing access.
  Authorization Issues: The user may not have the necessary authorizations to read the specified table.
  Database Issues: There could be a problem with the database itself, such as corruption or connectivity issues.
  Data Consistency: There may be inconsistencies in the data that prevent it from being read correctly.
  Transport Issues: If the table was recently transported, there may be issues with the transport itself.
  Configuration Errors: Incorrect configuration settings in the system could lead to this error.
  
  Solutions:
  
  
  Check Table Locking:
  
  Use transaction code SM12 to check for any locks on the table. If there are locks, you may need to wait for the other process to complete or unlock it if appropriate.
  
  
  
  Verify Authorizations:
  
  Ensure that the user has the necessary authorizations to access the table. You can check this using transaction SU53 after the error occurs.
  
  
  
  Database Health Check:
  
  Check the database logs for any errors or issues. You may need to involve your database administrator to resolve any underlying database problems.
  
  
  
  Data Consistency Check:
  
  Run consistency checks on the affected table. You can use transaction SE14 to check and repair database tables.
  
  
  
  Review Transport Logs:
  
  If the issue arose after a transport, review the transport logs for any errors or warnings that may indicate what went wrong.
  
  
  
  Configuration Review:
  
  Review the configuration settings related to the table and ensure they are set up correctly.
  
  
  
  SAP Notes:
  
  Check the SAP Support Portal for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  
  
  
  Related Information:
  
  
  Transaction Codes:
  
  SM12: To check for table locks.
  SU53: To check authorization issues.
  SE14: To check and repair database tables.
  ST22: To check for dumps that may provide more context on the error.
  
  
  
  SAP Support: If the issue persists after trying the above solutions, consider reaching out to SAP Support for further assistance, providing them with the error details and any relevant logs.
  
  
  By following these steps, you should be able to identify and resolve the underlying cause of the JB010 error in SAP.