How To Fix IW053 - Work center &1 plant &2 not allowed for Plant Maintenance

IW053 - Overview

• Message type: E = Error

• Message class: IW - Order Processing

• Message number: 053

• Message text: Work center &1 plant &2 not allowed for Plant Maintenance

What causes this issue?

You specified the <GL:work_center>work center</> &V1& from
the <GL:plant>plant</> &V2&. However, the routing usage specified
in the work center &V1& is not allowed for plant maintenance.

System Response

INCLUDE 'KEINE-VERARBEITUNG' OBJECT DOKU ID TX LANGUAGE E

How to fix this error?

Enter a work center whose routing usage is allowed for plant
maintenance.
If you want to use the work center rejected by the system in plant
maintenance, you must change its routing usage:

<DS:TRAN.CR02>Proceed</>
ENDIF
INCLUDE 'DARF-NICHT' OBJECT DOKU ID TX LANGUAGE E

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message IW053 - Work center &1 plant &2 not allowed for Plant Maintenance ?

  The SAP error message IW053 indicates that a specific work center in a particular plant is not allowed for Plant Maintenance (PM) activities. This error typically arises when there is an attempt to assign a work center to a maintenance order or task that is not valid for the specified plant.
  
  Cause:
  
  Work Center Configuration: The work center may not be properly configured for the plant in question. This could be due to missing or incorrect settings in the work center master data.
  Plant Assignment: The work center might not be assigned to the plant in the work center configuration.
  Status of Work Center: The work center may be inactive or not available for use in the specified plant.
  Authorization Issues: There may be authorization restrictions preventing the use of the work center in the specified plant.
  
  
  Solution:
  
  
  Check Work Center Configuration:
  
  Go to the transaction code CR02 (Change Work Center) and enter the work center and plant.
  Verify