How To Fix IUUC_TAB009 - Only test run - result not persisted!

SAP Error Message - Details

• Message type: E = Error

• Message class: IUUC_TAB - IUUC: Messages for table analysis

• Message number: 009

• Message text: Only test run - result not persisted!

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message IUUC_TAB009 - Only test run - result not persisted! ?

  The SAP error message IUUC_TAB009, which states "Only test run - result not persisted," typically occurs during the execution of a data transfer or replication process in SAP Landscape Transformation (SLT) or similar data replication scenarios. This message indicates that the operation was executed in test mode, and as a result, no changes were actually committed to the database.
  Cause:
  
  Test Mode Execution: The most common cause of this error is that the process was executed in test mode. In this mode, the system simulates the operation without making any actual changes to the database.
  Configuration Settings: The settings in the SLT configuration might be set to run in test mode, either intentionally or due to a misconfiguration.
  User Permissions: The user executing the operation may not have the necessary permissions to perform the actual data changes, leading to the system defaulting to a test run.
  
  Solution:
  
  Check Execution Mode: Ensure that the operation is not set to run in test mode. This can usually be done by checking the parameters or settings in the transaction or program you are using.
  Adjust Configuration: If you are using SLT, check the configuration settings to ensure that the replication is set to run in the correct mode (i.e., not in test mode).
  User Permissions: Verify that the user has the necessary authorizations to perform the operation. If not, you may need to adjust the user roles or permissions.
  Re-run the Process: After making the necessary adjustments, re-run the process to ensure that it executes in the correct mode and persists the results.
  
  Related Information:
  
  Transaction Codes: Depending on the context, you may be using transaction codes like LTRC (for SLT monitoring) or LTRC (for configuration).
  Documentation: Refer to the SAP Help Portal or specific SLT documentation for detailed information on configuration and execution modes.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  Logs and Traces: Review logs and traces for more detailed error messages or warnings that could provide further insight into the issue.
  
  If the problem persists after following these steps, consider reaching out to SAP support or consulting with a technical expert familiar with your specific SAP environment.