How To Fix IUUC_MAIN092 - Table &1: Don't specify both event and receiver field

SAP Error Message - Details

• Message type: E = Error

• Message class: IUUC_MAIN - IUUC: Main Message class

• Message number: 092

• Message text: Table &1: Don't specify both event and receiver field

What causes this issue?

A rule must be either an event-related or a field-related rule, but it
can't be both. Here, a rule assignment was found that would identify
both an event and a receiver field which is not allowed.

System Response

No rule assignment is created.

How to fix this error?

Correct the corresponding entry in table IUUC_ASS_RUL_MAP

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message IUUC_MAIN092 - Table &1: Don't specify both event and receiver field ?

  The SAP error message IUUC_MAIN092 indicates that there is a conflict in the configuration of a table in the SAP system, specifically related to the use of event and receiver fields in the context of SAP Landscape Transformation (SLT) replication. This error typically arises when both an event field and a receiver field are specified for the same table, which is not allowed.
  Cause:
  The error occurs when:
  
  You have defined both an event field (which triggers the replication process) and a receiver field (which is used to specify the target for the data) for the same table in the SLT configuration.
  This configuration is contradictory because the system expects either an event field or a receiver field, but not both at the same time.
  
  Solution:
  To resolve this error, you need to adjust the configuration of the table in question. Here are the steps you can take:
  
  
  Access the SLT Configuration:
  
  Go to the SLT configuration transaction (usually LTRC or LTMC).
  
  
  
  Identify the Table:
  
  Locate the specific table that is causing the error, as indicated by the error message (represented by &1).
  
  
  
  Check the Configuration:
  
  Review the settings for the table and check if both an event field and a receiver field are defined.
  
  
  
  Modify the Configuration:
  
  If both fields are defined, you need to decide which one is necessary for your replication scenario:
  
  If you need to use an event field, remove the receiver field.
  If you need to use a receiver field, remove the event field.
  
  
  
  
  
  Save Changes:
  
  After making the necessary adjustments, save the configuration.
  
  
  
  Re-run the Replication:
  
  Once the configuration is corrected, re-run the replication process to see if the error is resolved.
  
  
  
  Related Information:
  
  Documentation: Refer to the SAP Help Portal or SLT documentation for detailed information on configuring event and receiver fields.
  SLT Configuration Guide: There are specific guides available for setting up SLT, which can provide insights into best practices and common pitfalls.
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional troubleshooting steps.
  
  By following these steps, you should be able to resolve the IUUC_MAIN092 error and successfully configure your SLT replication settings.