How To Fix IUUC_IMIG010 - IMIG setup parameter for pack_ID &1 not defined

SAP Error Message - Details

• Message type: E = Error

• Message class: IUUC_IMIG - IUUC@IMIG Incremental migration (MDS)

• Message number: 010

• Message text: IMIG setup parameter for pack_ID &1 not defined

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message IUUC_IMIG010 - IMIG setup parameter for pack_ID &1 not defined ?

  The SAP error message IUUC_IMIG010 indicates that there is an issue with the configuration of the Initial Load for the SAP Landscape Transformation (SLT) Replication Server. Specifically, it suggests that the setup parameter for the specified pack_ID is not defined, which can prevent the initial load from proceeding correctly.
  Cause:
  
  Missing Configuration: The error typically arises when the configuration for the initial load is incomplete or missing for the specified pack_ID. This could happen if the initial load setup was not properly defined or if there was an oversight during the configuration process.
  Incorrect or Incomplete Parameters: The parameters required for the initial load might not have been set correctly, leading to the system being unable to find the necessary definitions for the specified pack_ID.
  Transport Issues: If the configuration was transported from another system, there might have been issues during the transport that led to missing parameters.
  
  Solution:
  
  Check Configuration: Go to the SLT configuration transaction (usually LTRC or LTMC) and verify that the initial load settings for the specified pack_ID are correctly defined. Ensure that all necessary parameters are set.
  Define Missing Parameters: If the parameters are indeed missing, you will need to define them. This can typically be done in the SLT configuration settings where you can specify the initial load parameters for the relevant pack_ID.
  Review Documentation: Consult the SAP documentation for SLT to ensure that you are following the correct steps for setting up the initial load and that all required parameters are included.
  Check for Transport Issues: If the configuration was transported, check the transport logs for any errors or warnings that might indicate why the parameters are missing. You may need to re-transport the configuration or manually adjust it in the target system.
  Consult SAP Notes: Look for any relevant SAP Notes that might address this specific error message or provide additional guidance on configuring the initial load.
  
  Related Information:
  
  SAP SLT Documentation: Review the official SAP documentation for SLT to understand the configuration requirements and best practices.
  SAP Community: Engage with the SAP Community forums where other users may have encountered similar issues and can provide insights or solutions.
  SAP Support: If the issue persists and you are unable to resolve it, consider reaching out to SAP Support for assistance, providing them with the error message and details of your configuration.
  
  By following these steps, you should be able to identify and resolve the issue related to the IUUC_IMIG010 error message in your SAP environment.