How To Fix GLE_MCA384 - Customizing error; No parameters found for process type &3

GLE_MCA384 - Overview

• Message type: E = Error

• Message class: GLE_MCA - Multicurrency Accounting

• Message number: 384

• Message text: Customizing error; No parameters found for process type &3

What causes this issue?

Customizing data could not be found for
<DS:GLOS.4CB1BB392A135A53E10000000A421391>MCA variant:</> &V1&
<DS:GLOS.4CB2902B634D56C7E10000000A421947>Process Category:</> &V2&
<DS:GLOS.4CB29263634D56C7E10000000A421947>Process Type:</> &V3&

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

The system terminated processing of the corresponding objects.

How to fix this error?

Make the relevant settings in the Customizing activity
<DS:SIMG.FAGL_MCA_VPRCTYPP>Maintain Parameters for Process Types</>.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

GLE_MCA384 - Details

• The SAP error message GLE_MCA384 indicates a customizing error related to the process type specified in the message. This error typically occurs when the system cannot find the necessary parameters for a specific process type in the configuration settings. Here’s a breakdown of the cause, potential solutions, and related information:
  
  Cause:
  
  Missing Customizing Settings: The error usually arises when the required customizing settings for the specified process type (denoted as &3 in the error message) are not maintained in the system.
  Incorrect Process Type: The process type being referenced may not be valid or may not have been properly defined in the system.
  Transport Issues: If the customizing settings were recently transported from another system, there may have been issues during the transport that resulted in missing or incomplete settings.
  
  
  Solution:
  
  
  Check Customizing Settings:
  
  Navigate to the relevant customizing transaction (e.g., SPRO) and check the settings for the process type in question.
  Ensure that all required parameters for