How To Fix GHO_MEAS030 - Qty Conversion failed from &1 to &2

SAP Error Message - Details

• Message type: E = Error

• Message class: GHO_MEAS - Message class for Measurements

• Message number: 030

• Message text: Qty Conversion failed from &1 to &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message GHO_MEAS030 - Qty Conversion failed from &1 to &2 ?

  The SAP error message GHO_MEAS030 indicates that there is a failure in quantity conversion from one unit of measure to another. This typically occurs in scenarios where the system is trying to convert quantities between different measurement units, and it cannot find a valid conversion factor or the conversion is not defined correctly.
  Causes:
  
  Missing Conversion Factors: The conversion factors between the two units of measure may not be defined in the system.
  Incorrect Unit of Measure: The units of measure being used may not be compatible or may not exist in the system.
  Configuration Issues: There may be issues in the configuration of the material master or the unit of measure settings.
  Data Entry Errors: There could be errors in the data entry where the wrong units are being used.
  
  Solutions:
  
  
  Check Unit of Measure Settings:
  
  Go to the transaction code CUNI (Unit of Measure Conversion) and verify if the conversion factors between the two units of measure are defined.
  If not, you can create the necessary conversion factors.
  
  
  
  Review Material Master Data:
  
  Check the material master data for the relevant material using transaction code MM03. Ensure that the units of measure are correctly defined and that the conversion factors are set up properly.
  
  
  
  Verify Configuration:
  
  Ensure that the configuration for units of measure is correctly set up in the system. This can be done through the SPRO transaction (SAP Reference IMG) under the relevant logistics area.
  
  
  
  Data Entry Validation:
  
  Review the data entry process to ensure that the correct units of measure are being used. This includes checking any input forms or interfaces that may be involved in the process.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or help resources for additional guidance on unit of measure conversions and related configuration.
  
  
  
  Related Information:
  
  
  Transaction Codes:
  
  CUNI: Manage Unit of Measure Conversions
  MM03: Display Material Master
  SPRO: SAP Reference IMG for configuration settings
  
  
  
  SAP Notes: Check for any relevant SAP Notes that may address specific issues related to unit of measure conversions.
  
  
  Testing: After making changes, perform tests to ensure that the conversion works as expected and that the error does not reoccur.
  
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.