How To Fix GEOCODING007 - No RFC destination or function defined for geocoder &1

SAP Error Message - Details

• Message type: E = Error

• Message class: GEOCODING - All Geocoding Messages

• Message number: 007

• Message text: No RFC destination or function defined for geocoder &1

What causes this issue?

No RFC destination or function was maintained in Customizing for the
geo-coding program specified in the error message.
Geo-coding programs confirm a fixed or, in this program, freely
selectable RFC destination under a particular function to the SAP
system (depending on the product). This data was not entered properly
in Customizing and is therefore unknown to the SAP System.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Call up Customizing (Transaktion SPRO). There choose "General settings"
-> "Set geo-coding" ->
<DS:SIMG.SIMG_GEOCD_GEOCD2CLS>
Register Geocoding Program in the System</> and
enter the respective RFC destination specified in the message and the
corresponding function names (this data can be obtained from the
program provider). For further information on geo-coding, refer to the
Customizing documentation for geo-docing and the provider of the
geo-coding program.

Procedure for System Administrators

Enter error messages for geo-coding in OSS, component BC-SRV-GEO.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message GEOCODING007 - No RFC destination or function defined for geocoder &1 ?

  The SAP error message GEOCODING007 indicates that there is no RFC (Remote Function Call) destination or function defined for the specified geocoder. This error typically arises when the system is trying to access geocoding services but cannot find the necessary configuration to connect to the geocoding service.
  Cause:
  
  Missing RFC Destination: The RFC destination for the geocoding service is not defined in the SAP system.
  Incorrect Configuration: The geocoding service may not be properly configured in the system.
  Inactive Geocoding Service: The geocoding service might not be active or available.
  Authorization Issues: The user may not have the necessary authorizations to access the geocoding service.
  
  Solution:
  
  
  Define RFC Destination:
  
  Go to transaction SM59 (RFC Destinations).
  Check if the required RFC destination for the geocoder is defined.
  If it is not defined, create a new RFC destination with the necessary connection parameters to the geocoding service.
  
  
  
  Check Configuration:
  
  Ensure that the geocoding service is properly configured in the system.
  Go to transaction SPRO and navigate to the relevant configuration settings for geocoding.
  
  
  
  Activate Geocoding Service:
  
  If the geocoding service is not active, you may need to activate it or ensure that the service is running.
  
  
  
  Check Authorizations:
  
  Verify that the user has the necessary authorizations to access the geocoding service.
  You may need to check roles and profiles assigned to the user.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to geocoding services for any specific configuration or troubleshooting steps.
  
  
  
  Contact SAP Support:
  
  If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: 
  
  SM59: For managing RFC destinations.
  SPRO: For configuration settings.
  
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error or provide additional guidance.
  Geocoding Services: Familiarize yourself with the specific geocoding service being used, as different services may have different configuration requirements.
  
  By following these steps, you should be able to resolve the GEOCODING007 error and ensure that the geocoding functionality works as intended.