How To Fix G3534 - Cons units are not contained in the reset set (see long text)

SAP Error Message - Details

• Message type: E = Error

• Message class: G3 - Messages for SAP Consolidation: Integration

• Message number: 534

• Message text: Cons units are not contained in the reset set (see long text)

What causes this issue?

In the current rollup, the data can be collected in the integrated
consolidation units in dimension &V1& with the integrated consolidation
type &V2& and with the data transfer method Rollup. In addition when
starting the rollup from the data monitor, one of the following must
apply:
the consolidation units belong to the consolidation group for which the
data entry is executed
the consolidation unit coincides with the consolidation unit, for which
the data entry is executed
All of these consolidation units are not included in the reset set.
But resetting the data is a prerequisite that the data for a
consolidation unit can be entered.

System Response

Rollup execution is terminated.

How to fix this error?

Check and correct the restrictions imposed by the reset set for the
consolidation units to be entered.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message G3534 - Cons units are not contained in the reset set (see long text) ?

  The SAP error message G3534, which states "Cons units are not contained in the reset set," typically occurs in the context of inventory management or logistics when dealing with consumption-based planning or stock management. This error indicates that there is a mismatch between the consumption units and the reset set defined in the system.
  Cause:
  
  Mismatch in Units: The consumption units that are being processed do not match the units defined in the reset set. This can happen if the configuration for the consumption units is not aligned with the reset set.
  Configuration Issues: There may be issues in the configuration of the material master or the settings for the consumption-based planning.
  Data Inconsistencies: There could be inconsistencies in the data related to the material or the consumption units, such as incorrect entries or missing data.
  
  Solution:
  
  Check Material Master Data: Review the material master data for the affected materials. Ensure that the consumption units are correctly defined and that they match the reset set.
  Review Configuration Settings: Check the configuration settings for consumption-based planning in the SAP system. Ensure that the settings for the reset set and consumption units are correctly aligned.
  Adjust Reset Set: If necessary, adjust the reset set to include the required consumption units. This may involve modifying the settings in the configuration to ensure that all relevant units are included.
  Data Consistency Check: Perform a data consistency check to identify any discrepancies in the data that may be causing the error. Correct any inconsistencies found.
  Consult Documentation: Refer to SAP documentation or help files for more detailed information on the specific configuration settings related to consumption units and reset sets.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes such as MM02 (Change Material), MM03 (Display Material), or SPRO (Customizing) to access the relevant settings and data.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional guidance on resolving it.
  Support: If the issue persists after checking the above points, consider reaching out to your SAP support team or consulting with an SAP expert for further assistance.
  
  By following these steps, you should be able to identify the cause of the G3534 error and implement a solution to resolve it.