How To Fix G00514 - Translation key '1' was used to translate cons unit &1 with method &2

SAP Error Message - Details

• Message type: E = Error

• Message class: G00 - SAP Consolidation

• Message number: 514

• Message text: Translation key '1' was used to translate cons unit &1 with method &2

What causes this issue?

The translation of the additional financial data concerning
consolidation unit &v1& uses
<DS:GLOS.3526B79EAFAB52B9E10000009B38F974>translation method</> &v2&.
<DS:GLOS.3526BA0FAFAB52B9E10000009B38F974>Translation key</> &v4& was
determined for FS item &v3&. However, only translation keys 1 and 5 are
valid.

System Response

Informational
Translation key 1 was used.

How to fix this error?

If applicable, change the definition of translation method &v2& in
Customizing.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message G00514 - Translation key '1' was used to translate cons unit &1 with method &2 ?

  The SAP error message G00514 indicates an issue related to the translation of a conversion unit in the system. This message typically arises when there is a problem with the translation key used for converting units of measure (UoM) in the system.
  Cause:
  
  Missing Translation Key: The translation key '1' may not be defined in the system for the specified conversion unit.
  Incorrect Method: The method used for the translation may not be appropriate or may not exist in the system.
  Configuration Issues: There may be configuration issues in the unit of measure settings or in the translation settings for the specific conversion unit.
  Data Inconsistencies: There could be inconsistencies in the master data related to units of measure.
  
  Solution:
  
  Check Translation Keys: Verify that the translation key '1' is correctly defined in the system. You can do this by navigating to the relevant configuration settings for units of measure.
  Review Conversion Methods: Ensure that the method used for the translation is valid and correctly configured. Check if the method exists and is properly set up in the system.
  Configuration Review: Go to the configuration settings for units of measure and ensure that all necessary settings are correctly defined. This includes checking the settings for conversion factors and translation keys.
  Data Consistency Check: Review the master data for the relevant units of measure to ensure there are no inconsistencies or missing entries.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on handling unit of measure translations and related configurations.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like OMW1 (for unit of measure settings) or CUNI (for unit of measure conversion) to check and modify the relevant settings.
  SAP Notes: Check SAP Notes for any known issues or patches related to this error message. SAP Notes can provide additional insights or solutions.
  Support: If the issue persists after checking the above points, consider reaching out to SAP support for further assistance.
  
  By following these steps, you should be able to identify and resolve the issue related to the G00514 error message in SAP.