How To Fix FRMLMSC145 - Standard explosion for output component &1 is no longer unique

SAP Error Message - Details

• Message type: E = Error

• Message class: FRMLMSC - RMS-FRM: Miscellaneous Messages for Formula

• Message number: 145

• Message text: Standard explosion for output component &1 is no longer unique

What causes this issue?

You have set the <DS:DE.FRMLE_DEFEXPL_FLG>standard explosion</>
indicator for output component &V1& for several formulas. Therefore,
the system can no longer explode this output component uniquely in
formula explosion, that is, the explosion path in which this output
component occurs is no longer unique.

System Response

In formula explosion for output component &V1&, the system uses the
first formula for which the <LS>standard explosion</> indicator is set.
INCLUDE RMS_FRM_EXPLOSION_GEN_INFO OBJECT DOKU ID TX

How to fix this error?

Correct the number of times the indicator is set if necessary. Then
first choose the application log (@DH@) to determine the formulas for
which the standard explosion indicator is set for component &V1&.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message FRMLMSC145 - Standard explosion for output component &1 is no longer unique ?

  The SAP error message FRMLMSC145 indicates that there is an issue with the standard explosion for an output component in a bill of materials (BOM) or a recipe. This error typically arises when the system finds multiple entries for the same output component, which leads to ambiguity in the explosion process.
  Cause:
  
  Duplicate Entries: The most common cause of this error is the presence of duplicate entries for the output component in the BOM or recipe. This can happen if the same component is defined multiple times with different parameters or configurations.
  Incorrect Configuration: The configuration of the BOM or recipe may not be set up correctly, leading to multiple valid paths for the same output component.
  Changes in Master Data: Changes in the master data (like material master or BOM) that affect the output component can also lead to this error.
  
  Solution:
  
  Check for Duplicates: Review the BOM or recipe for the output component in question. Look for duplicate entries and remove or consolidate them as necessary.
  Review Configuration: Ensure that the configuration of the BOM or recipe is correct. Make sure that the output component is defined uniquely and that there are no conflicting entries.
  Adjust Master Data: If there have been recent changes to the master data, verify that these changes are consistent and do not create ambiguity in the BOM or recipe.
  Use Unique Identifiers: If applicable, ensure that each output component has a unique identifier or key that distinguishes it from others.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidelines on managing BOMs and recipes to avoid such issues.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes like CS03 (Display BOM), CS02 (Change BOM), or C201 (Create Recipe) to investigate and modify the BOM or recipe.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Support: If the issue persists after checking for duplicates and reviewing configurations, consider reaching out to SAP support for further assistance.
  
  By following these steps, you should be able to resolve the FRMLMSC145 error and ensure that your output components are defined uniquely in your BOM or recipe.