How To Fix FNDEI_VIEW_PROV228 - Table &1 is already in replication mode.

SAP Error Message - Details

• Message type: E = Error

• Message class: FNDEI_VIEW_PROV - Message class for CDS View Replication

• Message number: 228

• Message text: Table &1 is already in replication mode.

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message FNDEI_VIEW_PROV228 - Table &1 is already in replication mode. ?

  The SAP error message FNDEI_VIEW_PROV228 indicates that a specific table (denoted as &1 in the message) is already in replication mode. This typically occurs in the context of SAP Data Services or SAP HANA when there is an attempt to replicate a table that is already being replicated or is in a state that does not allow for additional replication processes.
  Cause:
  
  
  Table Already in Replication: The most common cause is that the table you are trying to replicate is already being processed in replication mode. This can happen if:
  
  Another replication job is currently running for the same table.
  The table was previously set to replication mode and not properly released.
  
  
  
  Configuration Issues: There may be configuration settings that are causing the table to remain in replication mode.
  
  
  Locks or Transactions: There could be locks or ongoing transactions that prevent the table from being replicated again.
  
  
  Solution:
  
  
  Check Active Replication Jobs: Verify if there are any active replication jobs for the table. If so, you may need to wait for those jobs to complete before attempting to replicate the table again.
  
  
  Release Replication Mode: If the table is stuck in replication mode, you may need to manually release it. This can typically be done through the SAP Data Services or HANA management console, depending on your setup.
  
  
  Review Configuration: Check the configuration settings for the replication process to ensure that there are no misconfigurations causing the table to remain in replication mode.
  
  
  Restart Services: In some cases, restarting the relevant services or the entire system may help clear any locks or stuck processes.
  
  
  Consult Logs: Review the logs for any additional error messages or warnings that may provide more context on why the table is in replication mode.
  
  
  Contact Support: If the issue persists and you cannot determine the cause, consider reaching out to SAP support for further assistance.
  
  
  Related Information:
  
  SAP Documentation: Refer to the official SAP documentation for Data Services or HANA for detailed information on replication processes and error handling.
  SAP Community: The SAP Community forums can be a valuable resource for finding similar issues faced by other users and potential solutions.
  System Monitoring Tools: Utilize system monitoring tools to keep track of replication jobs and their statuses.
  
  By following these steps, you should be able to diagnose and resolve the FNDEI_VIEW_PROV228 error effectively.