How To Fix FDT_CHANGE_INFO744 - Connector changed from &1 to &2 (gateway &3)

SAP Error Message - Details

• Message type: E = Error

• Message class: FDT_CHANGE_INFO - FDT: Changes info in object for different versions

• Message number: 744

• Message text: Connector changed from &1 to &2 (gateway &3)

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message FDT_CHANGE_INFO744 - Connector changed from &1 to &2 (gateway &3) ?

  The SAP error message FDT_CHANGE_INFO744 indicates that there has been a change in the connector configuration for a specific data flow or integration scenario. The message specifies that the connector has changed from one state (or configuration) to another, and it also references the gateway involved in this change.
  Cause:
  
  
  Configuration Changes: The most common cause of this error is that the connector configuration has been modified. This could happen due to:
  
  Manual changes made by an administrator.
  Changes in the underlying system or application that the connector interfaces with.
  Updates or upgrades to the SAP system or the connected systems.
  
  
  
  System Updates: If there are updates or patches applied to the SAP system or the connected systems, it may lead to changes in the connector settings.
  
  
  Transport Requests: If changes were transported from one system to another (e.g., from development to production), it could lead to discrepancies in connector configurations.
  
  
  Solution:
  
  
  Review Connector Configuration: Check the configuration of the connector in the SAP system. Ensure that it is set up correctly and matches the expected settings.
  
  
  Check Change Logs: Look at the change logs to identify what changes were made to the connector. This can help in understanding why the change occurred.
  
  
  Revert Changes: If the change was not intended, consider reverting the connector configuration to its previous state.
  
  
  Consult Documentation: Refer to the SAP documentation or notes related to the specific connector you are using. There may be specific instructions or known issues related to the connector.
  
  
  Test the Connection: After making any changes, test the connection to ensure that it is functioning as expected.
  
  
  Contact SAP Support: If the issue persists and you cannot identify the cause or solution, consider reaching out to SAP support for assistance.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address this specific error message or provide guidance on connector configurations.
  Integration Scenarios: Understand the integration scenario you are working with, as different connectors may have different requirements and configurations.
  System Logs: Review system logs for any additional error messages or warnings that may provide more context about the issue.
  
  By following these steps, you should be able to diagnose and resolve the issue related to the FDT_CHANGE_INFO744 error message in SAP.