How To Fix FDT_CHANGE_INFO613 - Number of repeats was changed from &1 to &2

SAP Error Message - Details

• Message type: E = Error

• Message class: FDT_CHANGE_INFO - FDT: Changes info in object for different versions

• Message number: 613

• Message text: Number of repeats was changed from &1 to &2

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message FDT_CHANGE_INFO613 - Number of repeats was changed from &1 to &2 ?

  The SAP error message FDT_CHANGE_INFO613 indicates that there has been a change in the number of repeats for a certain field or data element in a form or document. This typically occurs in the context of SAP Forms and Document Management, particularly when using the Form Data Tool (FDT) or Adobe Forms.
  Cause:
  The error message is triggered when the configuration of a form or document is modified, specifically when the number of allowed repeats for a certain field is changed. This can happen due to:
  
  Form Design Changes: If a form is modified to allow more or fewer instances of a field or section.
  Data Model Changes: Changes in the underlying data model that affect how data is structured and repeated in the form.
  Versioning Issues: If different versions of a form are being used, and one version has a different configuration for repeats.
  
  Solution:
  To resolve this error, you can take the following steps:
  
  
  Review Form Configuration: Check the form design in the Form Data Tool or Adobe LiveCycle Designer to ensure that the number of repeats is set correctly according to your requirements.
  
  
  Check Data Model: Ensure that the data model used for the form is consistent with the form design. If the data model has changed, update the form accordingly.
  
  
  Version Consistency: Make sure that the version of the form being used matches the expected configuration. If there are multiple versions, ensure that the correct one is being referenced.
  
  
  Testing: After making changes, test the form thoroughly to ensure that the error does not reoccur and that the form behaves as expected.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on handling form configurations and error messages.
  
  
  Seek Support: If the issue persists, consider reaching out to SAP support or consulting with a technical expert who specializes in SAP Forms and Document Management.
  
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes that might address known issues or provide patches related to this error.
  Form Data Tool Documentation: Familiarize yourself with the capabilities and limitations of the Form Data Tool to better understand how to configure forms.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to identify the cause of the error and implement a solution to resolve it.