How To Fix FDT_CHANGE_INFO554 - Limit of &1 differences was reached

FDT_CHANGE_INFO554 - Overview

• Message type: E = Error

• Message class: FDT_CHANGE_INFO - FDT: Changes info in object for different versions

• Message number: 554

• Message text: Limit of &1 differences was reached

What causes this issue?

The system has determined that in the current object version, more than
&v1& changes have been made. This number is the predefined limit for
change recording. Any further changes that may have been made in this
version are omitted.
The predefined limit of &v1& changes is normally only exceeded if a mass
change has been done to an object (for example, a value shift for all
range checks in a decision table of several hundreds of lines). In such
cases, looking at the first &v1& changes that have been recorded should
be sufficient to give you an impression of the nature of the remaining
changes that have not been recorded.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message FDT_CHANGE_INFO554 - Limit of &1 differences was reached ?

  The SAP error message FDT_CHANGE_INFO554 with the description "Limit of &1 differences was reached" typically occurs in the context of the SAP Fiori Design Time (FDT) or when working with change documents in SAP. This error indicates that the system has reached a predefined limit for the number of differences or changes that can be tracked or displayed.
  
  Cause:
  
  Exceeding Change Limit: The error is triggered when the number of changes or differences exceeds the configured limit set in the system. This limit is often put in place to optimize performance and manage system resources effectively.
  Configuration Settings: The limit can be defined in the system settings, and it may vary based on the specific configuration of the SAP environment.
  
  
  Solution:
  
  
  Increase the Limit: If you have the necessary authorizations, you can increase the limit for the number of differences that can be tracked. This can typically be done in the configuration settings of the