How To Fix FASTEDM003 - Interval &1 of profile &2 is not from interval category 'Minutes'

FASTEDM003 - Overview

• Message type: E = Error

• Message class: FASTEDM -

• Message number: 003

• Message text: Interval &1 of profile &2 is not from interval category 'Minutes'

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

FASTEDM003 - Details

• The SAP error message FASTEDM003 indicates that there is an issue with the configuration of a time interval in a specific profile. This error typically arises when the system expects a time interval to be defined in minutes, but the provided interval does not meet this requirement.
  
  Cause:
  The error occurs when:
  
  The interval defined in the profile (identified by &2) is not set to a value that falls within the expected category of 'Minutes'.
  The configuration of the profile may have been incorrectly set up, or there may be a mismatch between the expected interval type and the actual value provided.
  
  
  Solution:
  To resolve the FASTEDM003 error, you can follow these steps:
  
  
  Check Profile Configuration:
  
  Go to the relevant configuration settings for the profile identified by &2.
  Verify the intervals defined in the profile. Ensure that the intervals are set in minutes as required.
  
  
  
  Adjust Interval Settings:
  
  If the intervals are set in a different unit (e.g., hours, seconds), change