How To Fix FARR_RAI897 - Report was started in simulation mode - no data was deleted

SAP Error Message - Details

• Message type: E = Error

• Message class: FARR_RAI - Revenue Accounting Item

• Message number: 897

• Message text: Report was started in simulation mode - no data was deleted

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message FARR_RAI897 - Report was started in simulation mode - no data was deleted ?

  The SAP error message FARR_RAI897 indicates that a report was executed in simulation mode, which means that no actual data changes (such as deletions) were performed. This is a common scenario in SAP when users want to test the report's functionality without affecting the actual data in the system.
  Cause:
  
  Simulation Mode: The report was intentionally or unintentionally run in simulation mode. This mode is often used to preview the results of a report or to ensure that the logic works correctly without making any changes to the database.
  User Settings: The user may have set the report to run in simulation mode through selection parameters or settings.
  Report Configuration: The report itself may be configured to default to simulation mode.
  
  Solution:
  
  Check Report Parameters: When executing the report, ensure that the option for simulation mode is unchecked. Look for a checkbox or parameter that indicates "Simulation" or "Test Mode" and make sure it is not selected.
  Review User Settings: If the report is consistently running in simulation mode, check the user-specific settings or defaults that may be causing this behavior.
  Execute in Production Mode: If you are ready to perform the actual data deletion or changes, run the report in production mode (non-simulation mode) after confirming that all parameters are set correctly.
  Consult Documentation: Refer to the specific documentation for the report you are using to understand its parameters and how to run it in the desired mode.
  
  Related Information:
  
  Testing Reports: Running reports in simulation mode is a best practice for testing purposes. It allows users to verify the output and ensure that the logic is correct before making any changes to the database.
  SAP Support: If you continue to experience issues or if the report does not behave as expected, consider reaching out to your SAP support team or consulting SAP Notes for any known issues related to the report.
  User Training: Ensure that users are trained on how to properly execute reports and understand the implications of running them in simulation mode versus production mode.
  
  By following these steps, you should be able to resolve the issue and run the report as intended.