How To Fix FAGL_REPORTING128 - Report &1 is adjusted: Variable changed to &3

SAP Error Message - Details

• Message type: E = Error

• Message class: FAGL_REPORTING - Reporting EHP3

• Message number: 128

• Message text: Report &1 is adjusted: Variable changed to &3

What causes this issue?

The source report uses variable &V2& for field &V4& in the <LS>General
Selections</>. However, variable &V2& is transferred to &V3&.

System Response

The system changes the variable for field &V4& from &V2& to &V3& in
report &V1&.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message FAGL_REPORTING128 - Report &1 is adjusted: Variable changed to &3 ?

  The SAP error message FAGL_REPORTING128 typically occurs in the context of financial reporting, particularly when using the General Ledger (G/L) reporting functionalities. This message indicates that a report (identified by &1) has been adjusted because a variable used in the report has been changed to a new value (&3). 
  Cause:
  
  Variable Change: The error is triggered when a variable in the report is modified, which can happen due to changes in the report configuration or user input.
  Inconsistent Data: If the report is based on certain parameters or variables that have been altered, it may lead to inconsistencies in the data being reported.
  User Input: Users may inadvertently change a variable that affects the report's output, leading to this message.
  
  Solution:
  
  Review Report Configuration: Check the configuration of the report to ensure that the variables are set correctly. If a variable has been changed, verify if it aligns with the intended reporting requirements.
  Check User Input: If the report is run by users, ensure that they are aware of the variables they are changing. Provide training or documentation to help them understand the impact of their changes.
  Re-run the Report: After confirming that the variables are set correctly, re-run the report to see if the error persists.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the report in question and the variables involved.
  Contact SAP Support: If the issue cannot be resolved through the above steps, consider reaching out to SAP support for further assistance.
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes such as FAGLB03 (Display G/L Account Balance) or FAGLB03N (Display G/L Account Balance - New).
  Report Variants: Check if there are any report variants that might be affecting the output and ensure they are configured correctly.
  SAP Notes: Look for any SAP Notes related to FAGL_REPORTING128 for known issues or patches that may address the problem.
  User Roles and Authorizations: Ensure that users have the appropriate roles and authorizations to run the reports without encountering issues.
  
  By following these steps, you should be able to address the FAGL_REPORTING128 error and ensure that your financial reports are generated correctly.