How To Fix ESH_TASK_MANAGER_MSG067 - Client is already configured for Enterprise Search

SAP Error Message - Details

• Message type: E = Error

• Message class: ESH_TASK_MANAGER_MSG - ESH Task Manager

• Message number: 067

• Message text: Client is already configured for Enterprise Search

What causes this issue?

Regarding Enterprise Search the client is not in an initial state. An
initial setup is not necessary.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

If you want to create connectors use the task list
SAP_ESH_CREATE_INDEX_SC.
If you want to repeat the initial setup for Enterprise Search reset the
Enterprise Search to initial state. Use task list SAP_ESH_RESET for
this.
If you want to change an existing RFC destination or DB connection to
SAP HANA reset the Enterprise Search to initial state.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message ESH_TASK_MANAGER_MSG067 - Client is already configured for Enterprise Search ?

  The SAP error message ESH_TASK_MANAGER_MSG067 indicates that the client you are working with is already configured for Enterprise Search. This typically occurs when you attempt to configure or reconfigure the Enterprise Search settings in a client that has already been set up for this functionality.
  Cause:
  
  Duplicate Configuration Attempt: The most common cause of this error is that the Enterprise Search has already been configured for the client, and you are trying to configure it again.
  Incorrect Client Selection: You might be working in the wrong client or environment where Enterprise Search is already set up.
  System State: The system might be in a state where it does not allow reconfiguration due to existing settings.
  
  Solution:
  
  
  Check Existing Configuration:
  
  Verify if Enterprise Search is already configured for the client. You can do this by checking the settings in the SAP system.
  Use transaction codes like ESH_COCKPIT or EHS_SEARCH to review the current configuration.
  
  
  
  Avoid Reconfiguration:
  
  If the client is already configured, you do not need to configure it again. Instead, you can proceed with using the existing configuration.
  If you need to make changes, look for options to modify the existing configuration rather than reconfiguring it entirely.
  
  
  
  Client Management:
  
  Ensure you are working in the correct client. If you need to configure Enterprise Search in a different client, switch to that client and perform the configuration there.
  
  
  
  Consult Documentation:
  
  Refer to the official SAP documentation for Enterprise Search to understand the configuration steps and prerequisites.
  
  
  
  Check for Notes and Patches:
  
  Sometimes, specific issues may be addressed in SAP Notes or patches. Check the SAP Support Portal for any relevant notes related to this error message.
  
  
  
  Contact SAP Support:
  
  If you are unable to resolve the issue, consider reaching out to SAP Support for assistance. They can provide guidance based on your specific system configuration and requirements.
  
  
  
  Related Information:
  
  Enterprise Search: This is a powerful search tool in SAP that allows users to search across various data sources within the SAP landscape.
  Configuration Steps: Familiarize yourself with the steps required to configure Enterprise Search, including setting up the search connector, indexing data, and managing search results.
  Transaction Codes: Common transaction codes related to Enterprise Search include:
  
  EHS_SEARCH: For managing search settings.
  EHS_COCKPIT: For accessing the Enterprise Search cockpit.
  
  
  
  By following these steps, you should be able to address the error message and continue working with Enterprise Search in your SAP environment.