How To Fix EPRO450 - Unit of meas. &1 of profile &4 not same as unit of meas. &2 in formula &3

EPRO450 - Overview

• Message type: E = Error

• Message class: EPRO - Messages for EDM Profile Processing

• Message number: 450

• Message text: Unit of meas. &1 of profile &4 not same as unit of meas. &2 in formula &3

What causes this issue?

The unit of measurement &v2& is defined in formula &v3&. However,
profile &v4&, which is allocated to the parameter for the formula, has
the unit of measurement &v1&.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

If the error occurs when creating a formula profile, allocate a profile
with the unit of measurement &v2&.
If the error occurs during billing, check your RTP interface.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EPRO450 - Unit of meas. &1 of profile &4 not same as unit of meas. &2 in formula &3 ?

  The SAP error message EPRO450 indicates a mismatch in the units of measurement (UoM) between different components in a formula or calculation. This error typically arises in the context of production planning, material management, or similar modules where units of measure are critical for accurate calculations.
  
  Cause:
  The error occurs when:
  
  The unit of measure defined in the profile (UoM &1) does not match the unit of measure used in the formula (UoM &2).
  The formula (identified by &3) is trying to use different units of measure that are incompatible with each other.
  There may be a configuration issue in the material master or the relevant master data where the units of measure are not aligned.
  
  
  Solution:
  To resolve the EPRO450 error, you can take the following steps:
  
  
  Check the Units of Measure:
  
  Review the units of measure defined in the relevant master data (e.g., material master, BOM, routing).
  Ensure that the units of measure used in the formula are