How To Fix EPRO140 - Register and profile must have identical units of measurement

EPRO140 - Overview

• Message type: E = Error

• Message class: EPRO - Messages for EDM Profile Processing

• Message number: 140

• Message text: Register and profile must have identical units of measurement

What causes this issue?

You tried to allocate profile &v1&, which is measured in unit &v2&, to
register &v3&, which is registered in unit &v4&.
If the allocation contains the role <LS>measured</> or <LS>forecast</>,
then the units of measurement must be identical for both the profile
and the registers.

System Response

INCLUDE ISU_VERARB OBJECT DOKU ID TX

How to fix this error?

INCLUDE ISU_KORR OBJECT DOKU ID TX

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EPRO140 - Register and profile must have identical units of measurement ?

  The SAP error message EPRO140, which states "Register and profile must have identical units of measurement," typically occurs in the context of SAP IS-U (Industry Solution for Utilities) when there is a mismatch between the units of measurement defined for a register (e.g., a meter) and the profile (e.g., a consumption profile) associated with that register.
  
  Cause:
  
  Mismatch in Units of Measurement: The most common cause of this error is that the register (meter) and the profile are configured with different units of measurement. For example, if the register is set to measure in kilowatt-hours (kWh) but the profile is set to measure in megawatt-hours (MWh), this error will occur.
  
  Configuration Issues: There may be issues in the configuration settings of the register or the profile in the SAP system.
  Data Entry Errors: Incorrect data entry during the setup of the register or profile can lead to this mismatch.
  
  
  Solution:
  
  
  Check Configuration: 
  
  Go to the configuration