How To Fix EN055 - Gas law deviation factor must be between 0.8 and 0.9

SAP Error Message - Details

• Message type: E = Error

• Message class: EN - IS-U installation/installation structure

• Message number: 055

• Message text: Gas law deviation factor must be between 0.8 and 0.9

What causes this issue?

The gas law deviation factor is normally in the specified range.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Check your entries.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EN055 - Gas law deviation factor must be between 0.8 and 0.9 ?

  The SAP error message EN055, which states that the "Gas law deviation factor must be between 0.8 and 0.9," typically occurs in the context of gas measurement or calculations within the SAP system, particularly in modules related to energy management or gas processing.
  Cause:
  The error is triggered when the gas law deviation factor, which is a parameter used to account for the non-ideal behavior of gases, is set outside the acceptable range of 0.8 to 0.9. This factor is crucial for accurate calculations in processes such as gas volume correction, energy content calculations, or other related measurements.
  Solution:
  To resolve this error, you should:
  
  
  Check the Configuration: Review the configuration settings in the SAP system where the gas law deviation factor is defined. Ensure that the value is set within the acceptable range (0.8 to 0.9).
  
  
  Adjust the Value: If the deviation factor is currently set outside this range, adjust it to a value that falls within the specified limits. This may involve consulting with a subject matter expert or referring to industry standards for the appropriate value based on the specific gas being measured.
  
  
  Review Input Data: If the deviation factor is derived from input data (e.g., temperature, pressure, gas composition), ensure that the input data is accurate and correctly entered into the system.
  
  
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on how to set or adjust the gas law deviation factor in your particular SAP module.
  
  
  Testing: After making adjustments, test the system to ensure that the error no longer occurs and that calculations are performed correctly.
  
  
  Related Information:
  
  
  Gas Law Deviation Factor: This factor is used in the Ideal Gas Law to correct for the behavior of real gases, which do not always behave ideally under all conditions. The deviation factor accounts for interactions between gas molecules and the volume occupied by the gas itself.
  
  
  SAP Modules: This error may be encountered in modules such as SAP IS-Oil, SAP Utilities, or other industry-specific solutions that deal with gas measurement and processing.
  
  
  Support: If you are unable to resolve the issue, consider reaching out to SAP support or your internal IT team for further assistance.
  
  
  By following these steps, you should be able to address the EN055 error and ensure that your gas measurements and calculations are accurate.