How To Fix EL348 - Device &1, register &2: Independent validations not possible

SAP Error Message - Details

• Message type: E = Error

• Message class: EL - IS-U meter reading data processing

• Message number: 348

• Message text: Device &1, register &2: Independent validations not possible

What causes this issue?

No expected consumption or reading was found for the register.
Independent validations could not be carried out.

System Response

The meter reading status is set to implausible.

The meter reading status is set to plausible.

How to fix this error?

Estimate the readings.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EL348 - Device &1, register &2: Independent validations not possible ?

  The SAP error message EL348, which states "Device &1, register &2: Independent validations not possible," typically occurs in the context of energy management or meter data management within SAP IS-U (Industry Solution for Utilities). This error indicates that the system is unable to perform independent validations for the specified device and register.
  Cause:
  The error can arise due to several reasons, including:
  
  Configuration Issues: The device or register may not be properly configured in the system, leading to inconsistencies that prevent independent validations.
  Data Integrity Problems: There may be missing or incorrect data related to the device or register, such as invalid readings or incorrect master data.
  System Settings: The validation settings for the device or register may not be correctly defined, which can lead to the inability to perform the required validations.
  Technical Issues: There could be underlying technical issues, such as problems with the database or application logic that prevent the validation process from executing correctly.
  
  Solution:
  To resolve the EL348 error, you can take the following steps:
  
  
  Check Device and Register Configuration:
  
  Verify that the device and register are correctly configured in the system. Ensure that all necessary master data is complete and accurate.
  
  
  
  Review Validation Settings:
  
  Check the validation settings for the device and register. Ensure that the independent validation rules are correctly defined and applicable to the specific device and register.
  
  
  
  Data Consistency Check:
  
  Perform a data consistency check to identify any discrepancies or missing data related to the device and register. Correct any issues found during this check.
  
  
  
  Consult Documentation:
  
  Refer to SAP documentation or notes related to the specific error message for additional guidance and troubleshooting steps.
  
  
  
  Contact SAP Support:
  
  If the issue persists after performing the above checks, consider reaching out to SAP support for further assistance. Provide them with detailed information about the error, including the device and register involved, and any relevant logs or screenshots.
  
  
  
  Related Information:
  
  Transaction Codes: Familiarize yourself with relevant transaction codes in SAP IS-U, such as EL31 (for meter reading) or EL32 (for validation).
  SAP Notes: Search for SAP Notes related to error EL348 in the SAP Support Portal, as there may be specific patches or updates that address this issue.
  User Forums: Engage with SAP community forums or user groups where similar issues may have been discussed, and solutions shared.
  
  By following these steps, you should be able to diagnose and resolve the EL348 error in your SAP system.