How To Fix EHPRC_CPM_CHECK172 - No settings for Supply Chain Coll. in Customizing for check &1

EHPRC_CPM_CHECK172 - Overview

• Message type: E = Error

• Message class: EHPRC_CPM_CHECK - Messages for Checks

• Message number: 172

• Message text: No settings for Supply Chain Coll. in Customizing for check &1

What causes this issue?

For this check, no Customizing for Supply Chain Collaboration is
maintained in activity <LS>Specify Checks for Compliance Requirement and
Check Criteria</><ZH>.</>

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Define the following data in the <LS>Specify Checks for Compliance
Requirement and Check Criteria</> Customizing activity:
Select or deselect the <ZK>Active</> checkbox.
Choose the Info Message, Warning, or Error status.
Enter the message to be displayed.

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_CPM_CHECK172 - No settings for Supply Chain Coll. in Customizing for check &1 ?

  The SAP error message EHPRC_CPM_CHECK172 indicates that there are no settings configured for Supply Chain Collaboration in the Customizing settings for the specific check referenced by &1. This error typically arises in the context of SAP's Supply Chain Management (SCM) or Advanced Planning and Optimization (APO) modules, where certain checks or validations are expected to have corresponding configuration settings.
  
  Cause:
  
  Missing Configuration: The most common cause of this error is that the necessary configuration for Supply Chain Collaboration has not been set up in the system.
  Incorrect Customizing Path: The error may also occur if the customizing path is not correctly followed or if the settings are incomplete.
  Transport Issues: If the configuration was recently transported from another system, it may not have been fully applied or may have been omitted.
  
  
  Solution:
  
  
  Check Customizing Settings:
  
  Navigate to the relevant customizing transaction (usually SPRO).
  Go to the section for Supply Chain Collaboration and ensure that all necessary settings are