How To Fix EHPRC_CPM_CHECK101 - Enter base unit of measure for specification &1

EHPRC_CPM_CHECK101 - Overview

• Message type: E = Error

• Message class: EHPRC_CPM_CHECK - Messages for Checks

• Message number: 101

• Message text: Enter base unit of measure for specification &1

Base check criterion 105 is mapped to message EHPRC_CPM_CHECK101.

What causes this issue?

You have entered the measured mass or the calculated mass in the
specification. However, you have not entered a base unit of measure.

System Response

The mass of the specification cannot be determined according to the base
unit.

How to fix this error?

Edit the specification in the substance workbench. Enter a value in the
<LS>Mass Information</> property for the <LS>Base Unit of Measure</>
characteristic.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

INCLUDE EHPRC_CPM_CHECK OBJECT DOKU ID TX
Base 105.

Error message extract from SAP system. Copyright SAP SE.

EHPRC_CPM_CHECK101 - Details

• The SAP error message EHPRC_CPM_CHECK101 indicates that a base unit of measure has not been defined for a specification in the SAP system. This error typically occurs in the context of Product Lifecycle Management (PLM) or Environmental Health and Safety (EHS) modules, where specifications for materials or products are managed.
  
  Cause:
  The primary cause of this error is that the specification (identified by &1 in the error message) does not have a base unit of measure assigned. The base unit of measure is essential for various processes, including inventory management, purchasing, and production planning, as it defines how the material is quantified.
  
  Solution:
  To resolve this error, you need to assign a base unit of measure to the specification. Here are the steps to do this:
  
  
  Access the Specification:
  
  Go to the relevant transaction in SAP (e.g., C202 for changing specifications).
  Enter the specification number that is causing the error.
  
  
  
  Edit the Specification:
  
  Navigate to the section where the