How To Fix EHPRC_CP01153 - Error during unit conversion from &1 to &2 (material &3, &4)

SAP Error Message - Details

• Message type: E = Error

• Message class: EHPRC_CP01 - Messages BOMBOS Interface (1.2)

• Message number: 153

• Message text: Error during unit conversion from &1 to &2 (material &3, &4)

What causes this issue?

The error occurred at material &V3& during conversion.

System Response

The system failed to convert units from &V1& to &V2&. The exception
&V4& was raised.

How to fix this error?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_CP01153 - Error during unit conversion from &1 to &2 (material &3, &4) ?

  The SAP error message EHPRC_CP01153 indicates that there is an issue during the unit conversion process for a specific material. This error typically arises in the context of handling materials in the SAP system, particularly when dealing with different units of measure (UoM) for a material.
  Cause:
  The error can occur due to several reasons, including:
  
  Missing Conversion Factors: The conversion factors between the units of measure are not defined in the system.
  Incorrect Unit of Measure: The specified units of measure may not be valid or recognized by the system.
  Material Master Data Issues: There may be inconsistencies or missing data in the material master record related to units of measure.
  Configuration Issues: The configuration settings for units of measure in the SAP system may not be set up correctly.
  
  Solution:
  To resolve the EHPRC_CP01153 error, you can take the following steps:
  
  
  Check Material Master Data:
  
  Go to the material master record (transaction code MM03) for the material in question.
  Verify that the units of measure are correctly defined and that conversion factors are set up properly.
  
  
  
  Define Conversion Factors:
  
  If conversion factors are missing, you can define them in the material master under the "Units of Measure" view.
  Ensure that the conversion factors between the base unit and the alternative units are correctly specified.
  
  
  
  Validate Units of Measure:
  
  Ensure that the units of measure being used are valid and exist in the system. You can check this in the configuration settings (transaction code OME1).
  
  
  
  Check Configuration Settings:
  
  Review the configuration for units of measure in the SAP system to ensure that it is set up correctly. This can be done in the IMG (Implementation Guide) under Logistics General > Material Master > Basic Settings > Units of Measure.
  
  
  
  Test the Conversion:
  
  After making the necessary changes, test the unit conversion again to see if the error persists.
  
  
  
  Consult Documentation:
  
  If the issue continues, refer to SAP documentation or consult with your SAP support team for further assistance.
  
  
  
  Related Information:
  
  Transaction Codes: MM03 (Display Material), OME1 (Define Units of Measure).
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  User Roles: Ensure that you have the necessary permissions to view and edit material master data and configuration settings.
  
  By following these steps, you should be able to identify and resolve the cause of the EHPRC_CP01153 error in SAP.