How To Fix EHPRC_CP00164 - Input value not convertible (value &1, unit &2)

SAP Error Message - Details

• Message type: E = Error

• Message class: EHPRC_CP00 - General messages

• Message number: 164

• Message text: Input value not convertible (value &1, unit &2)

Self-Explanatory Message

Since SAP believes that this specific error message is 'self-explanatory,' no more information has been given.The majority of messages in the SAP system have a message text, however this is frequently insufficient to comprehend or resolve the problem.

To make things easier, more detailed information is frequently added to describe the issue, how to fix it, and the necessary steps or configuration modifications.

Unfortunately, there isn't any extra information in this error notice.

What else can you do?

First, use our AnswerBot below to get a possible cause and solution (requires a premium subscription).

Also, review the in-depth Common Questions & Answers listed below; you could discover a solution there or be able to connect with others who have faced similar challenges.

You can also try searching the SAP support portal (support.sap.com) but you need a special user ID to access it. It is possible that an SAP support note exists that provides additional details about the mistake or even steps for fixing it.

Smart SAP Assistant

• What is the cause and solution for SAP error message EHPRC_CP00164 - Input value not convertible (value &1, unit &2) ?

  The SAP error message EHPRC_CP00164, which states "Input value not convertible (value &1, unit &2)," typically occurs in the context of handling measurement units or quantities in SAP, particularly in the Environment, Health, and Safety (EHS) module. This error indicates that the system is unable to convert the specified input value from one unit to another due to an issue with the value or the unit itself.
  Cause:
  
  Invalid Value: The input value provided may not be a valid number or may be in a format that SAP cannot interpret.
  Unsupported Unit: The unit specified may not be recognized by the system or may not be defined in the unit of measure (UoM) settings.
  Conversion Issues: There may be no defined conversion factor between the specified units, or the conversion logic may not be set up correctly in the system.
  Data Type Mismatch: The value may be of a different data type than what is expected (e.g., a string instead of a numeric value).
  
  Solution:
  
  Check Input Value: Ensure that the input value is a valid numeric value and is formatted correctly (e.g., no special characters, correct decimal separator).
  Verify Unit of Measure: Confirm that the unit specified is valid and recognized by the system. You can check the unit of measure settings in the SAP configuration.
  Review Conversion Settings: If applicable, check the conversion settings for the units involved. Ensure that there is a defined conversion factor between the units.
  Data Type Validation: Ensure that the data type of the input value matches the expected type in the system.
  Consult Documentation: Refer to SAP documentation or help resources for specific details on the units and values being used.
  
  Related Information:
  
  Unit of Measure Configuration: You can access the unit of measure configuration in SAP through transaction codes like OME1 (for defining units) or OME2 (for unit conversion).
  EHS Configuration: If this error occurs within the EHS module, check the relevant configuration settings for hazardous substances, safety data sheets, or other related areas.
  SAP Notes: Search for relevant SAP Notes in the SAP Support Portal that may address this specific error or provide additional troubleshooting steps.
  Testing: If possible, test the input values and units in a development or test environment to isolate the issue without affecting production data.
  
  By following these steps, you should be able to identify the root cause of the error and implement a solution to resolve it.