How To Fix EG472 - Specify &1 secondary windings for measurement

EG472 - Overview

• Message type: E = Error

• Message class: EG - IS-U device management

• Message number: 472

• Message text: Specify &1 secondary windings for measurement

What causes this issue?

Not enough secondary windings are permitted for measurement.

System Response

The system is determing whether one of the specified winding types is
permitted for measurement.

How to fix this error?

In the specified number of secondary windings, enter winding types that
are permitted for measurement.

Error message extract from SAP system. Copyright SAP SE.

EG472 - Details

• The SAP error message EG472 ("Specify &1 secondary windings for measurement") typically occurs in the context of configuring measurement points or devices in SAP IS-U (Industry Solution for Utilities). This error indicates that the system requires you to specify the number of secondary windings for a measurement device, such as a transformer or a meter.
  
  Cause:
  
  Missing Configuration: The error usually arises when the configuration for a measurement device is incomplete. Specifically, the system expects you to define the number of secondary windings for a transformer or measurement device, but this information is missing.
  Incorrect Master Data: The master data for the measurement point or device may not have been set up correctly, leading to the absence of required parameters.
  Data Entry Error: There might be a data entry error where the secondary windings were not entered or were entered incorrectly.
  
  
  Solution:
  
  
  Check Measurement Device Configuration:
  
  Navigate to the configuration settings for the measurement device in SAP.
  Ensure