How To Fix EEWMHIK070 - The control parameters for inspections cannot be determined

SAP Error Message - Details

• Message type: E = Error

• Message class: EEWMHIK - IS-U: Inspections

• Message number: 070

• Message text: The control parameters for inspections cannot be determined

What causes this issue?

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

System Response

How to fix this error?

Check whether the control parameters for inspections are maintained in
Customizing.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EEWMHIK070 - The control parameters for inspections cannot be determined ?

  The SAP error message EEWMHIK070, which states "The control parameters for inspections cannot be determined," typically occurs in the context of Quality Management (QM) within SAP. This error indicates that the system is unable to find the necessary control parameters for a quality inspection lot, which can be due to several reasons.
  Causes:
  
  Missing Control Indicators: The control indicators for the inspection lot might not be set up correctly in the material master or the inspection plan.
  Incorrect Inspection Plan: The inspection plan associated with the material might not be defined properly or might not exist.
  Master Data Issues: There could be issues with the master data, such as missing or incorrect data in the material master, vendor master, or other related master records.
  Configuration Issues: The configuration settings in the Quality Management module may not be set up correctly, leading to the inability to determine control parameters.
  Plant-Specific Settings: The settings for the specific plant may not be configured correctly, which can affect how inspections are processed.
  
  Solutions:
  
  Check Inspection Plan: Ensure that the inspection plan exists and is correctly assigned to the material. Verify that the plan contains the necessary control parameters.
  Review Material Master: Check the material master record for the relevant material to ensure that the quality management views are properly maintained, including the control indicators.
  Verify Configuration: Review the configuration settings in the Quality Management module to ensure that all necessary settings are in place. This includes checking the control indicators and inspection types.
  Check for Missing Data: Ensure that all required master data is complete and accurate. This includes checking the vendor master, material master, and any other relevant records.
  Consult Documentation: Refer to SAP documentation or help resources for specific guidance on the error message and related configuration settings.
  
  Related Information:
  
  Transaction Codes: You may need to use transaction codes such as MM03 (Display Material), QP01 (Create Inspection Plan), or QA32 (Change Inspection Lot) to investigate the issue further.
  SAP Notes: Check for any relevant SAP Notes that may address this specific error or provide additional troubleshooting steps.
  Support: If the issue persists after checking the above areas, consider reaching out to your SAP support team or consulting with an SAP QM expert for further assistance.
  
  By following these steps, you should be able to identify the root cause of the error and implement the necessary solutions to resolve it.