How To Fix EEWMHIK043 - No period can be determined for premise type &1/division &2

SAP Error Message - Details

• Message type: E = Error

• Message class: EEWMHIK - IS-U: Inspections

• Message number: 043

• Message text: No period can be determined for premise type &1/division &2

What causes this issue?

Cannot determine inspection periods for premise type &V1& and division
&V2&. These periods are required to calculate the next inspection date.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Enter inspection periods for premise type &V1& and division &V2&.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EEWMHIK043 - No period can be determined for premise type &1/division &2 ?

  The SAP error message EEWMHIK043 indicates that the system is unable to determine a valid period for a specific premise type and division combination. This error typically arises in the context of SAP's Environmental Management or Utilities modules, where period-based data is crucial for processing transactions related to billing, reporting, or regulatory compliance.
  
  Cause:
  
  
  Missing Configuration: The most common cause is that the configuration for the specified premise type and division is incomplete or missing. This could involve settings related to billing periods, rate plans, or other relevant configurations.
  
  
  Data Inconsistencies: There may be inconsistencies in the master data or transactional data that prevent the system from determining the correct period.
  
  
  Inactive Periods: The period you are trying to access may not be active or may have been closed in the system.
  
  
  Authorization Issues: Sometimes, the user may not have the necessary authorizations to access the required data.
  
  
  
  Solution:
  
  
  Check Configuration: 
  
  Go to the configuration settings for