How To Fix EEDMSET606 - Definition of profile parameter &1 is incomplete

EEDMSET606 - Overview

• Message type: E = Error

• Message class: EEDMSET - Messages for Settlement

• Message number: 606

• Message text: Definition of profile parameter &1 is incomplete

What causes this issue?

<ZH>&V2&</> is a parameter of the settlement procedure. The parameter
allocation cannot be checked because the Customizing settings for the
settlement procedure are incomplete.

System Response

INCLUDE ISU_VERARB OBJECT DOKU ID TX

How to fix this error?

If you want to exclude parameter &V1& from the check, undo the
selection.
If you want to save the profile parameter as a result of the settlement
procedure, note the following:
End the wizard and check the Customizing for settlement parameter &V1&
in settlement procedure &V3&. For each profile parameter, you must
enter a role for the profile allocation or a profile number.
Restart the wizard in order to check the parameter allocation and
automatically create any missing parameters.

Procedure for System Administrators

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

INCLUDE ISU_PENCIL OBJECT DOKU ID TX

Error message extract from SAP system. Copyright SAP SE.

EEDMSET606 - Details

• The SAP error message EEDMSET606 indicates that the definition of a profile parameter is incomplete. This typically occurs when a parameter that is expected to be defined in the system's profile is either missing or not fully specified.
  
  Cause:
  
  Incomplete Parameter Definition: The profile parameter specified in the error message is not fully defined in the system. This could be due to a missing value or incorrect syntax.
  Profile File Issues: The profile file (e.g., instance profile or default profile) may not have the necessary entries or may have been incorrectly modified.
  Transport Issues: If the parameter was transported from another system, it may not have been properly configured in the target system.
  System Configuration Changes: Changes made to the system configuration that did not properly update the profile parameters.
  
  
  Solution:
  
  
  Check Profile Parameters:
  
  Go to transaction RZ10 (Maintain Profile Parameters).
  Check the profile parameters for the specific parameter mentioned in the error message.
  Ensure that the parameter is defined