How To Fix EE_AMI_MSG113 - Message could not be sent for device &1

SAP Error Message - Details

• Message type: E = Error

• Message class: EE_AMI_MSG - Message Class for AMI Messaging

• Message number: 113

• Message text: Message could not be sent for device &1

What causes this issue?

A message could not be sent to device (category / serial number) &V1&
(equipment number&V4&). The reason and more information can be found
within preceeding protocol messages.
Technical ID of the message is: &V2&
Short extract of the message text:
&V3&

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EE_AMI_MSG113 - Message could not be sent for device &1 ?

  The SAP error message EE_AMI_MSG113, which states "Message could not be sent for device &1," typically occurs in the context of the Advanced Metering Infrastructure (AMI) module within SAP. This error indicates that there was an issue with sending a message related to a specific device, which could be a meter or another piece of equipment.
  Causes:
  
  Communication Issues: There may be network or communication problems preventing the message from being sent to the device.
  Device Status: The device may be in a status that does not allow it to receive messages (e.g., inactive, faulty, or not registered).
  Configuration Errors: Incorrect configuration settings in the AMI system or in the device settings could lead to this error.
  Message Format Issues: The message being sent may not be in the correct format or may contain invalid data.
  System Errors: There could be underlying system errors or issues with the SAP AMI application itself.
  
  Solutions:
  
  Check Device Status: Verify the status of the device in the SAP system. Ensure that it is active and properly configured to receive messages.
  Network Connectivity: Ensure that there are no network issues affecting communication between the SAP system and the device. Check for any firewalls or network configurations that may be blocking the message.
  Review Configuration: Check the configuration settings for both the SAP AMI system and the specific device. Ensure that all settings are correct and aligned with the requirements for message transmission.
  Message Format Validation: Review the message being sent to ensure it adheres to the expected format and contains valid data.
  Error Logs: Check the SAP application logs for any additional error messages or details that could provide more context about the failure.
  Retry Sending the Message: If the issue was temporary, try resending the message after addressing any identified issues.
  
  Related Information:
  
  SAP Notes: Check for any relevant SAP Notes or documentation that may address this specific error message or provide additional troubleshooting steps.
  Support: If the issue persists after trying the above solutions, consider reaching out to SAP support for further assistance. Provide them with detailed information about the error, including the device ID and any relevant logs.
  User Forums: Engage with SAP user communities or forums where other users may have encountered similar issues and can share their solutions.
  
  By following these steps, you should be able to diagnose and resolve the EE_AMI_MSG113 error in your SAP system.