How To Fix EDEREG436 - You have not yet defined parameter &1 for &2 (&3)

EDEREG436 - Overview

• Message type: E = Error

• Message class: EDEREG - Messages for Deregulation Scenarios

• Message number: 436

• Message text: You have not yet defined parameter &1 for &2 (&3)

What causes this issue?

You have not yet entered all of the parameters necessary to define a
parameter configuration. You can only omit an optional parameter if you
are not going to use it. Once you have entered an optional parameter for
a higher-level value, you have to enter that value for all other
higher-level values. You have not done this for parameter &v1&.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

How to fix this error?

Define the missing optional parameters for the higher-level parameter
&v2& (&v3&).

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EDEREG436 - You have not yet defined parameter &1 for &2 (&3) ?

  The SAP error message EDEREG436 indicates that a specific parameter has not been defined for a particular object or configuration. This error typically arises in the context of Electronic Data Interchange (EDI) or related configurations in SAP.
  
  Cause:
  The error message "You have not yet defined parameter &1 for &2 (&3)" generally means that the system is expecting a certain configuration parameter (represented by &1) to be defined for a specific object (represented by &2) in a particular context (represented by &3). This could occur due to:
  
  Missing Configuration: The required parameter has not been set up in the system.
  Incorrect Customization: The customization settings may not have been properly maintained.
  Transport Issues: If the configuration was transported from another system, it may not have been included or may have failed during the transport process.
  
  
  Solution:
  To resolve this error, you can follow these steps:
  
  
  Check Configuration:
  
  Go to the relevant configuration transaction in SAP (e.g., SPRO) and navigate