How To Fix EDEREG416 - You have not yet defined the mandatory parameter &1 for &2 (&3)

SAP Error Message - Details

• Message type: E = Error

• Message class: EDEREG - Messages for Deregulation Scenarios

• Message number: 416

• Message text: You have not yet defined the mandatory parameter &1 for &2 (&3)

What causes this issue?

You cannot save the parameter configuration because you have not yet
defined all the parameters.

System Response

The system issues an error message and will not allow you to continue with this transaction until the error is resolved.

INCLUDE ISU_VERARB OBJECT DOKU ID TX

How to fix this error?

Define the required parameter &v1& for the higher-level parameter &v2& (
&v3&) before you save the data.

Procedure for System Administrators

Error message extract from SAP system. Copyright SAP SE.

Smart SAP Assistant

• What is the cause and solution for SAP error message EDEREG416 - You have not yet defined the mandatory parameter &1 for &2 (&3) ?

  The SAP error message EDEREG416 indicates that a mandatory parameter has not been defined for a specific object or configuration. This error typically arises in the context of data element registration or configuration settings within the SAP system.
  Cause:
  The error occurs when a required parameter (denoted as &1) for a specific object (denoted as &2) is missing or not properly configured. The third parameter (&3) usually provides additional context, such as the specific configuration or setting that is incomplete.
  Solution:
  To resolve the EDEREG416 error, follow these steps:
  
  
  Identify the Missing Parameter: Check the error message for the specific parameter (&1) that is not defined. This will give you a clue about what needs to be configured.
  
  
  Access the Relevant Configuration:
  
  Navigate to the relevant configuration area in SAP where the object (&2) is defined. This could be in transaction codes like SPRO (for customizing) or other relevant transaction codes depending on the context of the error.
  
  
  
  Define the Missing Parameter:
  
  Once you locate the configuration, look for the section where the missing parameter should be defined. Enter the required value for the parameter.
  
  
  
  Save Changes: After entering the necessary information, save your changes.
  
  
  Test the Configuration: After making the changes, test the functionality that was causing the error to ensure that the issue has been resolved.
  
  
  Related Information:
  
  Documentation: Refer to SAP documentation or help files related to the specific module or configuration you are working with. This can provide insights into what parameters are mandatory and how to configure them correctly.
  SAP Notes: Check the SAP Support Portal for any relevant SAP Notes that might address this specific error message or provide additional troubleshooting steps.
  Community Forums: Consider searching or posting in SAP community forums or discussion groups, as other users may have encountered and resolved similar issues.
  
  If the problem persists after following these steps, it may be beneficial to consult with your SAP Basis or functional team for further assistance, as they may have more context about the specific configuration and its requirements.